Bissoy.com
Doctors Medicines MCQs Q&A

(i) Low short circuit current is required in dc system (ii) Fast control of the converter switches cannot effectively control the damping of the oscillations. Choose the most appropriate.

(i) Low short circuit current is required in dc system (ii) Fast control of the converter switches cannot effectively control the damping of the oscillations. Choose the most appropriate. Correct Answer Only (ii) is false

It’s an advantage the using converters in dc link can control the fast damping of the oscillations which occur in ac systems.

Related Questions

To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met?
1. Each end of the trunk link must be set to the IEEE 802.1e encapsulation.
2. The VTP management domain name of both switches must be set the same.
3. All ports on both the switches must be set as access ports.
4. One of the two switches must be configured as a VTP server.
5. A rollover cable is required to connect the two switches together.
6. A router must be used to forward VTP traffic between VLANs.
Which of the following methods are used for producing damping torque in analog instruments? 1) Air friction damping 2) Fluid friction damping 3) Eddy current damping 4) Electromagnetic damping
A 3 - ϕ CSI used for the speed control of an induction motor is to be realized using MOSFET switches as shown below. Switches S1 to S6 are identical switches. The proper configuration for realizing switches S1 to S6 is
Consider the following types of damping: 1. Air-friction damping 2.Fluid-friction damping 3.Eddy-current damping PMMC type instruments use which of the above?
Consider the following statements: 1. The voltage developed across the OFF switches of the half-bridge converter is the maximum dc-link voltage. 2. In the full-bridge converter, the voltage across the primary of the transformer is the dc link voltage. 3. The voltage developed across the OFF switches of the full-bridge converter is half the maximum dc-link voltage. Which of the above statements are correct?
In comparing the operation of the half-controlled 2-pulse circuit with that of the fully-controlled circuit, which of the following statements are evident? 1. Since half the thyristors are replaced by diodes, a half-controlled converter costs less than a fully-controlled converter. 2. Due to the freewheeling action with a half-controlled bridge-circuit power factor is improved in half-controlled converters. 3. The AC supply current is more distorted due to its zero periods with the half-controlled circuit, compared to a fully-controlled bridge circuit. Select the correct answer using the code given below :
In case of three-phase dual converter, one of the converter circuits is fired at an angle of 60°. For both the converter circuits to have equal average output voltage, what is the value of the firing angle for the other converter circuit?
If the damping factor is less than the damping factor at critical damping, the time response of the system is ___________
When we compare the half bridge converter and full bridge converter 1. The maximum collector current of a full bridge is only double that of the half bridge 2. Full bridge uses 4-power switches instead of 2, as in the double bridge. 3. Output power of a full bridge is twice that of a half bridge with the same input voltage and current. When of the above statements are correct?
Find critical damping coefficient if damping ratio is 0.5 and damping coefficient is 1.1.