Related Questions

Given are the steps to draw a perpendicular to a line at a point within the line when the point is near the centre of line. Arrange the steps. Let AB be the line and P be the point in it i. Join F and P which is perpendicular to AB. ii. Now C as centre take the same radius and cut the arc at D and again D as centre with same radius cut the arc further at E. iii. With centre as P take any radius and draw an arc (more than a semicircle) cuts AB at C. iv. Now D, E as centre take radius (more than half of DE) draw arcs which cut at F.
Given are the steps to draw a perpendicular to a line at a point within the line when the point is near the centre of a line. Arrange the steps. Let AB be the line and P be the point in it i. P as centre, take convenient radius R1 and draw arcs on the two sides of P on the line at C, D. ii. Join E and P iii. The line EP is perpendicular to AB iv. Then from C, D as centre, take R2 radius (greater than R1), draw arcs which cut at E.
Given are the steps to draw a perpendicular to a line from a point outside the line, when the point is nearer the centre of line. Arrange the steps. Let AB be the line and P be the point outside the line i. Take P as centre and take some convenient radius draw arcs which cut AB at C, D. ii. Join E, F and extend it, which is perpendicular to AB. iii. From C, D with radius R1 (more than half of CD), draw arcs which cut each other at E. iv. Again from C, D with radius R2 (more than R1), draw arcs which cut each other at F.
The normalised load impedance of the transmission line 50 ohm with a load of 30 ohm is
Given are the steps to draw a perpendicular to a line from a point outside the line, when the point is near an end of the line. Arrange the steps. Let AB be the line and P be the point outside the line i. The line ED is perpendicular to AB ii. Now take C as centre and CP as radius cut the previous arc at two points say D, E. iii. Join E and D. iv. Take A as center and radius AP draw an arc (semicircle), which cuts AB or extended AB at C.
Given are the steps to draw a perpendicular to a line from a point outside the line, when the point is near the centre of line. Arrange the steps. Let AB be the line and P be the point outside the line i. The line EP is perpendicular to AB ii. From P take convenient radius and draw arcs which cut AB at two places, say C, D. iii. Join E and P. iv. Now from centers C, D draw arc with radius (more than half of CD), which cut each other at E.
For a lossy transmission line, γ=0.02+j0.15 and is 20m long. The line is terminated with an impedance of a 400Ω. Then the input impedance of the transmission line given that the characteristic impedance of the transmission line is 156.13+j11.38Ω is:
A transmission line of pure resistance characteristic impedance is terminated with an unknown load. The measured value of VSWR on the line is 2 and a voltage minimum point is found to be at the load. The load impedance is then
Steps are given to find the normal and tangent for a cycloid. Arrange the steps if C is the centre for generating circle and PA is the directing line. N is the point on cycloid. i. Through M, draw a line MO perpendicular to the directing line PA and cutting at O. ii. With centre N and radius equal to radius of generating circle, draw an arc cutting locus of C at M. iii. Draw a perpendicular to ON at N which is tangent. iv. Draw a line joining O and N which is normal.
If a transmission line of a characteristic impedance 100 Ω is terminated with a load impedance of 300+j200 Ω, then the normalized load impedance is: