Bissoy.com
Doctors Medicines MCQs Q&A

4.If the specified fault setting for a winding is mentioned as 20%, then what can be inferred about it?

4.If the specified fault setting for a winding is mentioned as 20%, then what can be inferred about it? Correct Answer If a terminal fault has its current limited to the full load rating, then 20% of winding from neutral end will be unprotected

The fault setting implies that 20% of the neutral is unprotected.

Related Questions

Distributed winding is a type of winding in electrical machines where all the winding turns are arranged in a number of full pitches or fractional pitches. These coils are then placed in phase form or the commutator winding in slots spread around the periphery of the air gap. This type of winding used in
Consider the following statements regarding 'setting of cement': 1. Low-heat cement sets faster than OPC. 2. Final setting time decides the strength of cement. 3. Initial setting time of Portland PozzoIlona is 30 minutes. 4. Air-induced setting is observed when stored under damp conditions. 5. Addition of gypsum retards the setting time. Which of the above statements are correct?
Consider a stator winding of an alternator with an internal high – resistance ground fault. The currents under the fault condition are as shown in the figure. The winding is protected using a differential current scheme with current transformers of ratio 400 / 5 A as shown. The current through the operating coils is
Three – phase to ground fault takes place at locations F1 and F2 in the system shown in the figure If the fault takes place at location F1, then the voltage and the current at bus A are VF1 and IF1 respectively. If the fault takes place at location F2, then the voltage and the current at bus A are VF2 and IF2 respectively. The correct statement about voltages and currents during faults at F1 and F2 is
A sustained three phase fault occurs in the power system shown in the figure. The current and voltage phasors during the fault (on a common reference), after the natural transients have died down, are also shown. Where is the fault located?  
The following question has three statements. Study the question and the statements to decide which of the statement(s) is/are necessary to answer the question. A train starts from point A towards point B, but after ‘n’ hours, its speed becomes 2/3rd of the normal speed due to some fault. Find the value of n. Statement I: The fault occurred at a distance of 800 km from the destination Statement II: Had the fault occurred 200 km further, the train would have got late by 30 min Statement III: The train got late by 40 min
Calculate the value of the fault impedance if the fault voltage is 2 V and fault current is 4 A.
The fault not belonging to the classification of fault with the attitude of fault as basis ___________
The fault where fault strike is parallel to the dip of the layers broken and disrupted by the fault?
The fault which is the result of both fault scarps and fault-line scarps is?