Bissoy.com
Doctors Medicines MCQs Q&A

For a transmission line under study of failure analysis, it is observed that the current at the receiving end is same as that of the sending end, then what can be concluded about the nature of the transmission line?

For a transmission line under study of failure analysis, it is observed that the current at the receiving end is same as that of the sending end, then what can be concluded about the nature of the transmission line? Correct Answer It is short TL

It is a short transmission line as the capacitance considered is zero and so the line charging current is also zero.

Related Questions

Consider the following statements: The calculation performed using short line approximate model instead of nominal-π model for a medium length transmission line delivering lagging load at a given receiving end voltage always results in higher: 1. Sending end current 2. Sending end power 3. Regulation 4. Efficiency Which of these statements are correct?
Seven people, Kamal, Nalini, Namrata, Sheela, Shakti, Arun and Sukanya, study three different subjects - Mathematics, Science and Physics in three different schools - P, Q and R. Less than two and no more than three people study the same subject. Less than two and not more than three people study in the same school. Namrata studies Mathematics in school P which has only one more student named Shakti. Kamal does not study in school R but he is a student of mathematics. Shakti and Sukanya study the same subject. Sheila studies physics in school R. Nalini is also a student of school R. Arun and Sukanya do not study in school R. Nalini and Shakti study science. Arun is a student of which subject?
A single phase 50 hz, generator supplies an inductive load of 5 MW at a power factor of 0.8 lagging using OHTL over 20 km. The resistance and reactance are 0.39Ω and 3.96 Ω. The voltage at receiving station is maintained at 10 KV. The sending end voltage is 11.68 kV. If the voltage regulation is reduced to 50%, then the receiving end current at this operation mode will be _____________
The transmission line is represented as a two-port network as shown in the figure. The sending end voltage and current are expressed in terms of receiving end voltage and current for the network as VS = A VR + B IR IS = C VR + D IR where A, B, C, and D are generalized circuit constants. The condition for symmetry for the network is
In which of the following cases a partnership does not exist?
(1) Lender of money receiving profits.
(2) Servants or agents receiving profits.
(3) Widow or child of a deceased partner receiving profits.
(4) Seller of goodwill receiving profits.
In which of the following cases, a partnership does not exist?
1. Lender of money receiving profits.
2. Servants or agents receiving profits.
3. Widow or child of a deceased partner receiving profits.
4. Seller of goodwill receiving profit.
Consider the following statements regarding typical analysis of bolt failure :  1. 15% failure of bolt occur at the fillet under the head. 2. 50% failure of bolt occur at the end of threads on the shank. 3. 80% failure of bolt occur in the threads that are in contact with the nut. Which of the above statements is/are correct ?
A single phase 50 hz, generator supplies an inductive load of 5 MW at a power factor of 0.8 lagging using OHTL over 20 km. The resistance and reactance are 0.39Ω and 3.96 Ω. The voltage at receiving station is maintained at 10 KV. The sending end voltage is 11.68 kV. The new sending end voltage at the half the voltage regulation is _____________
Which of the following statements is most relevant in the context of Job Analysis? Choose the correct answer from the code given below. (i) Job Analysis helps in identifying the right person for the right job. (ii) A person cannot judge the job from the point of view of its suitability. (iii) Job analysis helps in job satisfaction and job efficiency. (iv) Through Job Analysis an employer cannot evaluate the prospective employee to judge his fitness or otherwise for the job. (v) Job Analysis helps in planning appropriate training programs. (vi) Job Analysis defines client needs in specific terms. (vii) Job Analysis assists in knowing the personnel specifications for various jobs.
Assume a 275 kV transmission line having the following line constants:A = 0.85∠5° ; B = 200∠75° If a load is connected at receiving end at unity power factor but maintaining the same voltage profile. The receiving end voltage if the compensation equipment is not installed will be __________