Bissoy.com
Doctors Medicines MCQs Q&A

In the below given circuit, at the instant T1 the main SCR is triggered, the voltage across the load terminal is

In the below given circuit, at the instant T1 the main SCR is triggered, the voltage across the load terminal is Correct Answer Vs

When the main SCR is gated, the commutating circuit remains inactive. Hence the load is directly connected to Vs through the SCR. Considering SCR as an ideal switch Vo = Vs.

Related Questions

Consider the following statements: 1. In a silicon controlled rectifier (SCR), if the cathode gate is reverse-biased, then the SCR cannot fire at all. 2. The turn-on time of an SCR increases with temperature. 3. After an SCR is turned on, it can be made to turn off again by reverse biasing the gate. 4. Gate recovery time is the minimum time that the anode voltage must be maintained below holding voltage VH to turn off the SCR. Which of these statements are correct?
A voltage source Vs = Vm sinωt is connected in series with a resistance R and an SCR. At some firing angle delay of α a positive gate pulse is applied to the SCR which turns on the SCR. Considering ideal conditions, at the instant α the voltage at the resistor terminals Vo
Two monoshot multivibrators, are positive edge triggered (M1) and another negative edge triggered (M2), are connected as shown in figure The monoshots M1 and M2 when triggered produce pulses of width T1 and T2 respectively, where T1 > T2. The steady state output voltage v0 of the circuit is
Consider the following statements: 1. The voltage developed across the OFF switches of the half-bridge converter is the maximum dc-link voltage. 2. In the full-bridge converter, the voltage across the primary of the transformer is the dc link voltage. 3. The voltage developed across the OFF switches of the full-bridge converter is half the maximum dc-link voltage. Which of the above statements are correct?
You install Terminal Services on a Windows 2000 domain controller. You install Terminal Services Client on users' client computers. Users report that when they try to connect to the Terminal server, they receive the following error message: "The local policy of this system does not allow you to logon interactively." When you attempt to log on to the Terminal server as an administrator from a user's computer, you log on successfully. You want users to be able to log on to the Terminal server. What should you do?
A single-phase voltage controller, using one SCR in anti parallel with a diode, feeds a load R and Vs = 230 V. For a firing angel of 90° for the SCR, the PMMC voltage connected across R would read
Below shown ideal circuit is triggered at a firing angle of α. The voltage across the SCR is zero from ωt =
Below a set of instructions is given on preparation of instant coffee. Using the instructions, fill in the blank in the sentence given below.
(i) Boil water.
(ii) Take one teaspoon each of instant coffee and sugar.
(iii) Add boiling water and stir the mixture vigorously.
(iv) Warm milk separately.
(v) Add warm milk to the mixture and stir.
(iv) Hot instant-coffee is ready to drink.
The MOSFET circuit below has Vt = 1V, knW/L = 0.8 mA/V2 and VA = 40V. If terminal Z is grounded, X is connected to a signal source having a resistance of 1 MΩ and terminal Y is connected to a load resistance of 40 kΩ, find the voltage gain from the signal source to the load.
When a transformer is operating on no load the primary applied voltage is approximately balanced by a. Primary Induced emf b. Secondary Induced emf c. Terminal voltage across the secondary d. Voltage drop across the resistance and reactance Which statement/s is/are correct?