Bissoy.com
Doctors Medicines MCQs Q&A

The nanocones electrodeposited with CuSO4 based electrolyte have poor mechanical stability.

The nanocones electrodeposited with CuSO4 based electrolyte have poor mechanical stability. Correct Answer False

Mechanically stable nanocones, having good electrical contact to the substrate, can be generated via the method of electrodeposition using CuSO4 – based electrolyte in a two-electrode configuration. These have improved mechanical stability and solid contact interface which increase emission current values to a great extent in comparison to metallic cylindrical nanowires.

Related Questions

Consider the following statements 1. Value of transient stability limit will be lower than steady-state stability limit 2. Transient stability limit is the maximum flow of power through a particular point in the power system without loss of stability when large and sudden disturbances occur 3. Critical clearing angle is related to the steady-state stability limit Which of the above statement(s) is/are correct?
In case of an automobile battery, following are the reasons which will cause a defect of
1. Very high charging rate
2. High specific gravity of electrolyte
3. Freezing of electrolyte
4. Improper level of electrolyte
5. Mechanical damage due to rough handling or not fixed in the vehicle
In this question, a statement is given followed by four conclusions. Choose the conclusion(s) which best fit(s)logically. Statement: Ability is poor man's wealth. Conclusions: I. A poor man can earn wealth if he has ability. II. A wealthy man is always able. III. A poor man is always able. IV. A poor man has the ability to earn wealth. 
Read the given passage and answer the question that question that follow. On paper the Indian Government spends a lot on the poor but in reality the poor barely get anything. The major reason for this misallocation of funds is corruption. As the money has to pass through several stages before reaching the poor, most of it is taken by the corrupt officials and the small amount that reaches the poor, is used inadequately. This is one of the problems that slows down the progress of the country. Which of the following argument could be made from the above passage?
Ecu/cu2+0=-0.34V এবং EFe/Fe2+0=-0.44V হলে, i) তামার পাত্রে FeSO4 দ্রবন রাখা যায়। ii) তামার পাত্রে FeSO4 দ্রবন রাখা যায় না। iii) লৌহ পাত্রে CuSO4 দ্রবণ রাখা যায়। iv) লৌহ পাত্রে CuSO4 দ্রবণ রাখা যায় না। উল্লিখিত উক্তিসমূহের জন্য নিচের কোন উত্তরটি সঠিক?
Za + CuSO4→ZnSO4+ Cu  বিক্রিয়াটিতে-i. বিক্রিয়ক Zn এর জারণ সংখ্যা +2ii. CuSO4 বিজারিত হয়েছেii. iZnSO4 এ S এর জারণ সংখ্যা +6নিচের কোনটি সঠিক?
The oxygen activity in a liquid metal can be-measured by a concentration cell using stabilised zirconia electrolyte PO2(1) | ZrO2 based solid electrolyte | PO2(2)
Where, PO2(1) is the reference oxygen pressure and PO2(2) is the oxygen pressure in equilibrium with liquid metal. If, F is Faraday constant, the EMF of the cell is equal to
Consider the following statements with respect to the feedback from the control systems: 1. The feedback can improve stability or be harmful to stability if it is not properly applied. 2. The feedback can always improve stability. 3. In many situations, the feedback can reduce the effect of noise and disturbance on system performance. 4. In general, the sensitivity of the system gain of a feedback system of a parameter variation depends on where the parameter is located. Select the correct statements.
Consider the following statements with respect to the feedback of the control systems. i. Feedback can improve stability or be harmful to stability if it is not properly applied. ii. Feedback can always improve stability iii. In many situations the feedback can reduce the effect of noise and disturbance on system performance. iv. In general the sensitivity of the system gain of a feedback system of a parameter variation depends on where the parameter is located.
Consider the following statements with respect to the feedback of the control systems: 1. Feedback can improve stability or be harmful to stability if it is not properly applied. 2. Feedback can always improve stability 3. In many situations the feedback can reduce the effect of noise and disturbance on system performance. 4. In general the sensitivity of the system gain of a feedback system of a parameter variation depends on where the parameter is located.