Bissoy.com
Doctors Medicines MCQs Q&A

____ is the process of non-linear compression and expansion of analog electronic signal.

____ is the process of non-linear compression and expansion of analog electronic signal. Correct Answer Companding

Companding is the process of non-linear compression and expansion of analog electronic signal. The dynamic range of the signal is compressed at the transmitter and is expanded to the normal range at the receiver. It helps in the preservation of information content.

Related Questions

_____________ results from a case of nonlinear dispersion compensation in which the nonlinear dispersion compensation in which the nonlinear chirp caused by self-phase modulation balances, postpones, the temporal broadening induced by group velocity delay.
. . . . . . . . results from a case of nonlinear dispersion compensation in which the nonlinear dispersion compensation in which the nonlinear chirp caused by self-phase modulation balances, postpones, the temporal broadening induced by group velocity delay.
From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
Consider the following statements regarding modulation : 1. The communication systems, where a weak signal is transmitted by the use of a modulation is essential in carrier signal. 2. When the frequency of the high frequency signal is varied in accordance with the intensity of the low-frequency weak signal, the modulation is said to be frequency modulation. 3. The process of recovering original baseband signal from the modulated signal is called phase modulation. Which of the above statements are correct ? 
What are the important block(s) required to process an input analog signal to get an output analog signal?
If the signal to be analyzed is an analog signal, we would pass it through an anti-aliasing filter with B as the bandwidth of the filtered signal and then the signal is sampled at a rate __________
The S/H is a digitally controlled analog circuit that tracks the analog input signal during the sample mode and then holds it fixed during the hold mode to the instantaneous value of the signal at the time the system is switched from the sample to the hold mode.
Consider the following statements regarding electronic voltmeter. 1) The detection of low-level signals is not possible using the electronic voltmeter 2) MOSFET is used at the input of the electronic voltmeter 3) Vacuum tube voltmeters (VTVM) consumes more power as compared to any non-electronic voltmeter. Which of the following is / are incorrect?
In vapor compression cycle having dry saturated vapor at the end of compression the work done is given by? H2 – Enthalpy of vapor after compression H1 – Enthalpy of vapor before compression
In vapor compression cycle having dry saturated vapor at the end of compression the refrigeration effect is given by? H1 – Enthalpy of vapor before compression H4 – Enthalpy of vapor before entering evaporator H2 – Enthalpy of vapor after compression