Bissoy.com
Doctors Medicines MCQs Q&A

In_____, the highest-power signal is demodulated to estimate its bitstream.

In_____, the highest-power signal is demodulated to estimate its bitstream. Correct Answer sequential interference cancellation

In sequential interference cancellation, the highest-power signal is demodulated to estimate its bitstream. By employing this technique, co-channel interference from strongest interferer can be reduced substantially.

Related Questions

What is the correct sequence of preparing an estimate? 1. Detailed estimate 2. Approximate estimate 3. Supplementary estimate 4. Revised estimate
Match the column. a. Detailed estimate 1. Estimate of additional works during the process b. Supplementary estimate 2. Prepared for approx. rates initially c. Revised estimate 3. Includes details and cost of everything d. Rough estimate 4. Prepared when the costs exceed more than 5%
Consider the following statements regarding modulation : 1. The communication systems, where a weak signal is transmitted by the use of a modulation is essential in carrier signal. 2. When the frequency of the high frequency signal is varied in accordance with the intensity of the low-frequency weak signal, the modulation is said to be frequency modulation. 3. The process of recovering original baseband signal from the modulated signal is called phase modulation. Which of the above statements are correct ? 
In a regenerative transponder, the signal is demodulated and modulated again before transmission.
Consider the following solution to the producer-consumer synchronization problem. The shared buffer size is ?. Three semaphores empty, full and mutex are defined with respective initial values of 0, ? and 1. Semaphore empty denotes the number of available slots in the buffer, for the consumer to read from. Semaphore denotes the number of available slots in the buffer, for the producer to write to. The placeholder variables, denoted by P, Q, R, and S, in the code below can be assigned either empty or full. The valid semaphore operations are: wait ( ) and signal ( ). Producer: Consumer: do {         wait (P) ;         wait (mutex) ;         //Add item to buffer         signal (mutex) ;         signal (Q) ; } while (1) ; do {          wait (R) ;          wait (mutex) ;          //Consume item from buffer          signal (mutex) ;          signal (S) ; } while (1) ;   Which one of the following assignments to P, Q, R and S will yield the correct solution?
A rectangular pulse train s(t) as shown in the figure is convolved with the signal cos2(4π × 103t). The convolved signal will be a
Signal Processing mcq question image
The team from which of the following institutes modulated the light source and demodulated them at the observer’s end to achieve sharper images in foggy weather conditions?
Which of the following expression can be used to compute processing demand providedif, Ps, Pbs, Pbb and Pmo stands for IF, source, bitstream, baseband, and management overhead processing demand respectively?
Bitstream processing performs _____
A signal contains components at 400 Hz and 2400 Hz This signal modulates a carrier of frequency 100 MHz. However, after demodulation, it is found that the 400 Hz signal component is present. The channel bandwidth is 15 kHz. What is the reason for the higher frequency signal not to be detected properly?