Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

The change in length due to a tensile or compressive force acting on a body is given by (where P = Tensile or compressive force acting on the body, $$l$$ = Original length of the body, A = Cross-sectional area of the body and E = Young's modulus for the material of the body)
Tresca or maximum-shear stress criteria assumes that yielding occurs when the maximum shear stress reaches a value of the shear stress in the uniaxial tension test. Assume the principal stress being σ1, σ2, σ3 where σ1 is largest, and σ3 is the smallest principal stresses. Find the value of minimum shear stress to cause yielding, given that yield stress in tension is equal to σo?
From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
Consider the following statements: 1. Cross-section of a member of truss experiences uniform stress 2. Cross-section of a beam experiences minimum stress 3. Cross-section of a beam experiences linearly varying stress 4. Cross-sections of truss members experience only compressive stress Which of the above statements are correct?
Certain facts about Force are given below. Identify the true information. A. Force is a scalar quantity. B. Gravitational force is the weakest force. C. Electromagnetic force is the strongest force. D. When sum of all forces acting on a body is zero, the body is said to be in a state of equilibrium.
Consider the following statements: When a thick plate is subjected to external loads: 1. State of plane stress occurs at the surface 2. State of plane strain occurs at the surface 3. State of plane stress occurs in the interior part of the plate 4. State of plane strain occurs in the interior part of the plate Which of these statements are correct?
The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.
Which of the following statements regarding stress related factors is/are true and false?
1. Burnout Stress Syndrome (BOSS) is a debilirating psychological condition brought about by unrelieved work stress.
2. 'Good' and 'bad' stresses are also referred to as 'Distress' and 'Eustress' respectively.
3. It is natural and healthy to maintain optimal level of stress.
4. Rustout Stress Syndrome (ROSS) is indicative of stress overload.
5. Anxiety is a state of emotional tension characterised by Apprehension, fearfulness, and psychic pain.
Consider the following statements: The basic reason why shafts are made of steel and its alloys is: 1. The shaft is subjected to normal stress. 2. The shaft stress alternates with respect to time. 3. The shaft is subjected to pure compressive stress. 4. The shaft is subjected to the stress of constant intensity. Which of these statements are correct?
In the case of 3-dimension state of stress, if one of the stress values, say, principal stress direction becomes compressive, the fracture stress reduces significantly.