Bissoy.com
Doctors Medicines MCQs Q&A

What is the ratio of stress to strain called?

What is the ratio of stress to strain called? Correct Answer Youngs Modulus

The ratio of stress to strain is called as Youngs Modulus. It is a mechanical property that measures the stiffness of a body. It establishes a relationship between stress and strain of a body. The youngs modulus graph or the stress-strain graph of a body showing elastic property is a straight line which shows the stress is proportional to strain.

Related Questions

From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
The true strain rate is given as ϒ, and conventional strain rate is given as ε. The engineering strain is equal to e. The relationship between conventional strain rate and true strain rate is _______
What is the relationship between engineering stress and true stress? Given that; s = engineering stress, σ = true stress, e = engineering strain, ε = true strain. d) σ = se+1
The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.
Tresca or maximum-shear stress criteria assumes that yielding occurs when the maximum shear stress reaches a value of the shear stress in the uniaxial tension test. Assume the principal stress being σ1, σ2, σ3 where σ1 is largest, and σ3 is the smallest principal stresses. Find the value of minimum shear stress to cause yielding, given that yield stress in tension is equal to σo?
Which of the following statements regarding stress related factors is/are true and false?
1. Burnout Stress Syndrome (BOSS) is a debilirating psychological condition brought about by unrelieved work stress.
2. 'Good' and 'bad' stresses are also referred to as 'Distress' and 'Eustress' respectively.
3. It is natural and healthy to maintain optimal level of stress.
4. Rustout Stress Syndrome (ROSS) is indicative of stress overload.
5. Anxiety is a state of emotional tension characterised by Apprehension, fearfulness, and psychic pain.
The stress corresponding to ______ of strain in the stress-strain curve of mild steel is known as proof stress.
The relationship between the true strain and engineering strain is given as _____ Where e=conventional strain, ε= Engineering strain
Consider the following statements concerning elasticity of concrete 1. Stress-strain behaviour of concrete is a straight line up to 10% of ultimate stress. 2. Strain determination is obtained from tangent modulus. 3. Modulus of elasticity, of concrete is also called as secant modulus. Which of the above statements are correct?
Every direct stress is always accompanied by a strain in its own direction and an opposite kind of strain in every direction, at right angles to it. Such a strain is known as