Bissoy.com
Doctors Medicines MCQs Q&A

Vibration galvanometer is used as a detector in AC circuit instead of normal galvanometer.

Vibration galvanometer is used as a detector in AC circuit instead of normal galvanometer. Correct Answer True

Vibration galvanometer is used as a detector in AC circuit instead of normal galvanometer. Normal galvanometer is used in DC bridge circuit for balancing and detecting. If a normal galvanometer is placed in an AC circuit then its needle will continuously deflect back and forth and will never be stable.

Related Questions

Which of the following are the basic differences between vibration signature and noise signature? 1. Vibration signature is essentially in the frequency range zero to 100 cps whereas noise signature is in the range 20 cps to 3000 cps. 2. Vibration signature has well-defined peaks whereas the noise signal is smeared. 3. The intensities of noise signatures arc much less than that of vibration signatures. 4. Detection of vibration signature calls for a microphone whereas that of noise can do with a pickup. Select the correct answer using the code given below.
The current passing through a galvanometer is 30 mA, resistance of the galvanometer is 50 Ω and a shunt is 1 Ω is connected to the galvanometer. What is the maximum current that can be measured by this ammeter?
Statement: Resonance is a special case of forced vibration in which the nature and frequency of vibration of the body are the same as the impressed frequency and the amplitude of forced vibration, is maximum. Reason: The amplitude of forced vibrations of a body increases with an increase in the frequency of the externally impressed periodic force.
Consider a binary digital communication system with equally likely 0's and 1's. When binary 0 is transmitted the detector input can lie between the levels -0.25V and +0.25V with equal probability: when binary 1 is transmitted, the voltage at the detector can have any value between 0 and 1 V with equal probability. If the detector has a threshold of 0.2 V (i.e., if the received signal is greater than 0.2 V, the bit is taken as 1), the average bit error probability is
Which of the following is the frequency range used for Vibration Galvanometer?
Consider the following statements regarding the 'strength of cement': 1. Strength test on cement is made on cubes of the cement-sand mix. 2. Water to be used for the paste is 0.2P, where P is the water needed for normal consistency. 3. The normal consistency is determined on Le Chatelier's apparatus. 4. Cubes are cast in three layers in leak-proof moulds further compacted in each layer by vibration on a machine. Which of the above statements are correct?
A circuit breaker is a piece of equipment which can (i) make or break a circuit either manually or by remote control under normal conditions. (ii) break a circuit automatically under fault conditions. (iii) make a circuit either manually or by remote control under fault conditions Choose the correct answer. 
If a galvanometer has a fixed core made of nonmagnetic metallic material, then the oscillating coil of the galvanometer comes to rest very quickly due to:
A galvanometer whose resistance is 50 Ω has 25 divisions in it. When a current of 4 × 10-4A passes through it, its needle (pointer) deflects by one division. To use this galvanometer as a voltmeter of range 2.5 V, it should be connected to a resistance of
A certain current on passing through a galvanometer produces a deflection of 100 divisions. When a shunt of one ohm is connected, the deflection reduces to 1 division. The galvanometer resistance is