Bissoy.com
Doctors Medicines MCQs Q&A

Microprocessor based electrical motors are used for ____

Microprocessor based electrical motors are used for ____ Correct Answer Actuation purpose in robots

Microprocessor based electrical motors are used for actuation purpose in robots. The other functions such as Correction before a fault occurs, Providing intelligence or prediction of fault in the system is done using Artificial intelligence.

Related Questions

Following statements are given for DC motors (a) DC motors require less maintenance than AC motors (b) DC motors cannot provide high starting torque (c) DC motors are not suitable for very high-speed applications (d) The methods of speed control of DC motors are simpler and less expensive than those of AC motors Which of the following statements are correct?
Consider the following statements regarding ac drives: 1. For the same kW rating, ac motors are 20% to 40% light weight as compared to dc motors. 2. The ac motors are more expensive as compared to same kW rating dc motors. 3. The ac motors have low maintenance as compared to dc motors. Which of the above statements are correct?
Which of the following statements regarding interface circuit are correct? 1. Electrical buffering is needed when the peripheral operates at a different voltage or current to that on the microprocessor bus system or there are different ground references. 2. Timing control is needed when the data transfer rates of the peripheral and the microprocessor are different. 3. Changing the number of lines is needed when the codes used by the peripherals differ from those used by the microprocessor.
Which of the following statements are correct for synchronous motors? 1. Synchronous motors are well-suited for direct connection top reciprocating compressors. 2. Over-excited synchronous motors are most commonly used for power factor improvement. 3. Synchronous motors are generally used for current regulation of long transmission lines Select the correct answer using the code given below.
Microprocessor-based electrical motors are used for ____
Match the following Device Conversion of Energy (a) Windmill (i) Chemical Energy to electrical energy (b) Bulb (ii) Kinetic Energy to Electrical Energy (c) Electrical Cell (iii) Sound Energy to Electrical energy (d) Microphone (iv) Electrical Energy to Light Energy
Two statements are given, followed by two conclusions numbered I and II. Assuming the statements to be true, even if they seem to be at variance with commonly know facts, decide which of the conclusions logically follow(s) from the statements. Statements: All wires are motors. All motors are pumps. Conclusions: i. All wires are pumps. ii. Some motors are wires.
What does hydropower change A. Kinetic energy to electrical energy B. Mechanical energy from electrical energy C. Chemical energy to electrical energy D. Wind energy to electrical energy
In the following question, sentences of a paragraph have been jumbled and labelled as A, B, C and D. You are required to rearrange the jumbled sentences of the paragraph and mark your response accordingly by selecting the correct option. A: Transformers can also be used for isolation, where the voltage in equals the voltage out, with separate coils not electrically bonded to one another. B: Transformers are most commonly used for increasing low AC voltages at high current (a step-up transformer) or decreasing high AC voltages at low current (a step-down transformer) in electric power applications. C: It was discovered in 1831. D: A transformer is a passive electrical device that transfers electrical energy from one electrical circuit to another.
A microprocessor integrates the arithmetic logic and control circuitry of a computer into one chip. The first microprocessor was built by a group of engineers at the Intel Corpn. Can you tell who headed this group?