Bissoy.com
Doctors Medicines MCQs Q&A

Signal tracing can be done by simple diode trace or CRO in circuit tracing techniques.

Signal tracing can be done by simple diode trace or CRO in circuit tracing techniques. Correct Answer True

To find fault in equipment, it can be divided into 3 parts: i) Section ii) Stages and iii) Components. Here the faulty section is isolated first. In determination of faulty stage/section signal tracing can be done by simple diode trace or CRO. If signal is absent at output, the stage is considered faulty.

Related Questions

From where does tracing start to determine the faulty component in an isolated stage in circuit tracing techniques?
What will be seen on the screen of CRO, when a sinusoidal voltage signal is applied to the vertical deflection plate of this CRO with no simultaneous signal applied to the horizontal deflection plate?
From the given circuit diagram, considering the diode to be a silicon semiconductor diode, what is the magnitude of diode current? (Use an appropriate model of the diode)
Consider the following statements with regard to Lissajous pattern on a CRO: 1. It is a stationary pattern on the CRO 2. It is used for precise measurement of frequency of a voltage signal 3. The ratio between frequencies of vertical and longitudinal voltage signals should be an integer to have a steady Lissajous pattern Which of the above statements is/are correct?
Consider the following statements regarding modulation : 1. The communication systems, where a weak signal is transmitted by the use of a modulation is essential in carrier signal. 2. When the frequency of the high frequency signal is varied in accordance with the intensity of the low-frequency weak signal, the modulation is said to be frequency modulation. 3. The process of recovering original baseband signal from the modulated signal is called phase modulation. Which of the above statements are correct ? 
The input voltage V1 of the circuit the circuit is 2V and resistor has a resistance of 1KΩ. The cut-in voltage of the silicon diode is 0.7V and the reverse saturation current is 10-8A. The temperature at which diode operates is 30°C. The voltage across resistor when diode starts conducting is _________________
Consider the following diodes: 1. Gunn diode 2. Schottky diode 3. Crystal diode 4. Tunnel diode Which of these can be used as detector diodes?
For a diode the transition capacitance was 15pF. The diode is replaced with another diode of same material with twice cross sectional area. Terminal voltage remains unchanged. The capacitance of new diode is __________
Find the current Ix if the voltage across the diode is 0.5V. The reverse saturation current of diode 10-11A, the cut-in voltage of diode is 0.6V. Assume that the temperature at which diode operates is 25°C. The resistance R1=2KΩ.
Select the option that is true regarding the following two statements labeled Assertion (A) and Reason (R). Assertion (A): Whenever we measure an electrical signal, there are chances of over current which leads to overheating of the meter. In such cases, the meter can be protected by using a semiconductor diode of suitable rating. Reason (R): As soon as the diode is short-circuited, the meter current is diverted through the diode. As a result, the meter is being protected from excess heating.