Bissoy.com
Doctors Medicines MCQs Q&A

High gain is not achievable at microwave frequencies using BJT amplifiers because:

High gain is not achievable at microwave frequencies using BJT amplifiers because: Correct Answer ports are not matched at high frequencies

At higher frequencies, if higher bandwidth is desired, a compromise on maximum achievable gain is made. But at these higher frequencies, the ports of the amplifier are not matched to 50 Ω.

Related Questions

Which of the following statements are correct? 1. A lowpass filter passes low frequencies and stops high frequencies. 2. A highpass filter passes high frequencies and rejects low frequencies 3. A bandpass filter passes frequencies within a frequency band and attenuates frequencies outside the band. 4. A bandstop filter passes frequencies within the band and blocks/attenuates frequencies outside a frequency band.
Microwave resonators are used in 1. Microwave oscillators 2. Microwave narrowband amplifiers 3. microwave frequency meters Which of the above are correct?
Two non-inverting amplifiers, with gain =1 and gain=20 are made using identical operational amplifiers. As compared to the unity gain amplifier, the amplifier with gain=20 has ___________
You are given two amplifiers, A and B, to connect in cascade between a 10-mV, 100-kΩ source (S) and a 100-Ω load (L). The amplifiers have voltage gain, input resistance, and output resistance as follows: for A, 100 V/V, 10 kΩ, 10 kΩ, respectively; for B, 1 V/V, 100 kΩ, 100 Ω, respectively. Your problem is to decide how the amplifiers should be connected so that the voltage gain is maximum.
Choose the correct statement(s) i) The gate circuit impedance of MOSFET is higher than that of a BJT ii) The gate circuit impedance of MOSFET is lower than that of a BJT iii) The MOSFET has higher switching losses than that of a BJT iv) The MOSFET has lower switching losses than that of a BJT
Assertion (A): A high electron mobility transistor is based upon modulation-doped (GaAs - AlGaAs) single heterojunction structure. Reason (R): HEMT shows a very high noise figure and very low gain at very high microwave frequencies up to 70 GHz.
If Raj scores 27 marks less than the highest scorer and the highest scorer has 2 marks less than the maximum achievable score, then find the score that Raj scored, if the maximum achievable score is 100.
In order to increase the bandwidth of tuned amplifiers, one can use: 1. Tuned circuit with inductance having high Q factor 2. Double tuned amplifier with two tuned circuits coupled by mutual inductance 3. Staggered tuned amplifiers in which different tuned circuits which are cascaded are tuned to slightly different frequencies
Chopper stabilized dc amplifiers are complex amplifiers having ________ amplifiers incorporated in the module.
A dealer bought a microwave and a geyser for Rs. 15000, and sold them earning a total profit of 22%, such that he sold the microwave at a profit of 20% after giving a discount of 10% on its marked price and the geyser at a profit of 25%. How much total profit percentage he would have earned, if he had sold the microwave at a discount of 15%?