Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

If 10 watt is applied to the input port of a standard Wilkinson divider, then the sum of the power measured at the two output ports of the Wilkinson coupler is
Wilkinson power divider is an equal split power divider.
For an equal-split Wilkinson power divider of 50Ω system impedance, the characteristic impedance of quarter wave transmission line used is:
For a Wilkinson power divider of insertion loss L and the coupler is matched to the external circuitry, and then the gain of the coupler in terms of insertion loss is:
In the following question, the 1st and the last part of the sentence/passage are numbered 1 and 6. The rest of the sentence/ passage is split into four parts and named P, Q, R and S. These four parts are not given in their proper order. Read the sentence/ passage and find out which of the four combinations is correct. 1.During a research experiment, a marine biologist placed a shark into a large holding tank and then released several small bait fish into the tank. P. Again, the shark quickly attacked.  This time, however, the shark slammed into the fibreglass divider and bounced off. Q. As you would expect, the shark quickly swam around the tank, attacked and ate the smaller fish. R. The marine biologist then inserted a strong piece of clear fibreglass into the tank, creating two separate partitions.She then put the shark on one side of the fibreglass and a new set of bait fish on the other. S. Eventually, about an hour into the experiment, the shark gave up. 6. The marine biologist then removed the fibreglass divider, but the shark didn’t attack.  The shark was trained to believe a barrier existed.
In a clapp oscillator with three capacitor C1, C2, C3, C1 is used as upper capacitor in voltage divider, C2 is used as lower capacitor in voltage divider and C3 is the third capacitor. For perfect operation which of these capacitor should have minimum value?
In a clapp oscillator with three capacitor C1, C2, C3, C1 is used as upper capacitor in voltage divider, C2 is used as lower capacitor in voltage divider and C3 is the third capacitor. For perfect operation of clapp oscillator value of C3 should be __________
A T junction power divider can be used only for division of power.
The power delivered to the input port of a resistive power divider is equal to the source voltage applied.
Which of the following types of power have to be pre-justified; and, when the need and occasion arise, must very soon be post-justified ?  1. Reward power 2. Coercive power 3. Legitimate power 4. Expert power 5. Referent power Which of the above statements are correct ?