Bissoy.com
Doctors Medicines MCQs Q&A

Which of the following is not a way to represent convolution code?

Which of the following is not a way to represent convolution code? Correct Answer Linear matrix

Linear matrix is not a way to represent convolution code. Various ways of representing convolution codes are generator matrix, generator polynomial, logic tables, state diagram, tree diagram and trellis diagram.

Related Questions

In the following figure, Triangle represent school, Square represent college, Circle represent Students, Rectangle represent Private college, and Trapezium represent Distance learning. Which set of letter represent college student that opted for distance learning.
Which of the following command options are displayed when you use the Router# show frame-relay ? command?
1. dlci
2. neighbors
3. lmi
4. pvc
5. map
In the following figure Rectangle represent rugby players, Circle represent Chess player, triangle represent Sprinter, and square represent Kabaddi Player. Which set of letters represent Chess player and Kabaddi player but not sprinter.
In the following figure Rectangle represent Bread, Circle represent Pizza, triangle represent Burger, and Square represent Cheese. Which set of letter represent cheese and bread.
Which of the following commands will display the current IP addressing and the layer 1 and 2 status of an interface?
1. show version
2. show protocols
3. show interfaces
4. show controllers
5. show ip interface
To enable EIGRP, which of the following would you use?
1. Router1(config-if)# ipv6 ospf 10 area 0.0.0.0
2. Router1(config-if)# ipv6 router rip 1
3. Router1(config)# ipv6 router eigrp 10
4. Router1(config-rtr)# no shutdown
5. Router1(config-if)# ipv6 eigrp 10
Which two of the following commands will place network 10.2.3.0/24 into area 0?
1. router eigrp 10
2. router ospf 10
3. network 10.0.0.0
4. network 10.2.3.0 0.0.0.255 area0
5. network 10.2.3.0 0.0.0.255 area 0
Which three commands can be used to check LAN connectivity problems on a router?
1. show interfaces
2. show ip route
3. tracert
4. ping
5. dns lookups
You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?
1. Switch (config-if) # ip access-group 10
2. Switch (config-if) # switchport port-security maximum 1
3. Switch (config) # access-list 10 permit ip host 1
4. Switch (config-if) # switchport port-security violation shutdown
5. Switch (config) # mac-address-table secure
In the following figure, rectangle represent Dieticians, circle represent Floral designers, triangle represents gardeners and square represent Asians. Which set of letters represent floral designers who are not Gardeners?