Bissoy.com
Doctors Medicines MCQs Q&A

Which of the following is not an example of block code?

Which of the following is not an example of block code? Correct Answer Convolution code

Hamming codes, cyclic codes and BCH codes are the example of block codes. Convolution code does not come in the category of block code. Some other examples of block codes are Reed Solomon codes, Golay codes and Hadamard codes.

Related Questions

Pyroxenes are class of silicate minerals, which exhibit a polymeric chain structure, as shown below
S-Block and P-Block Elements mcq question image
Its simplest repeating unit is
Which of the following command options are displayed when you use the Router# show frame-relay ? command?
1. dlci
2. neighbors
3. lmi
4. pvc
5. map
In which of the following block would you find the Rare Earth Elements? s-block p-block d-block f-block
A spring mass system is on a horizontal plane. Spring constant is 2N/m & mass of block is 2kg. The spring is compressed by 10cm and released. A small ball is released from a height of 2m above the block on the horizontal plane. At what time should the ball be left if the block is released from the extreme position at t=0, given that the ball has to fall on the block when the speed of block is maximum?
A spring block system is on a horizontal surface. The block is compressed by 10cm. What should be the coefficient of friction between the block and ground such that the block comes to a stop at the mean position? Mass of block = 0.5kg & spring constant = 3N/m.
Which of the following commands will display the current IP addressing and the layer 1 and 2 status of an interface?
1. show version
2. show protocols
3. show interfaces
4. show controllers
5. show ip interface
To enable EIGRP, which of the following would you use?
1. Router1(config-if)# ipv6 ospf 10 area 0.0.0.0
2. Router1(config-if)# ipv6 router rip 1
3. Router1(config)# ipv6 router eigrp 10
4. Router1(config-rtr)# no shutdown
5. Router1(config-if)# ipv6 eigrp 10
Which two of the following commands will place network 10.2.3.0/24 into area 0?
1. router eigrp 10
2. router ospf 10
3. network 10.0.0.0
4. network 10.2.3.0 0.0.0.255 area0
5. network 10.2.3.0 0.0.0.255 area 0
Which three commands can be used to check LAN connectivity problems on a router?
1. show interfaces
2. show ip route
3. tracert
4. ping
5. dns lookups
You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?
1. Switch (config-if) # ip access-group 10
2. Switch (config-if) # switchport port-security maximum 1
3. Switch (config) # access-list 10 permit ip host 1
4. Switch (config-if) # switchport port-security violation shutdown
5. Switch (config) # mac-address-table secure