Bissoy.com
Doctors Medicines MCQs Q&A

Which of the following logic describes the EXOR gate?

Which of the following logic describes the EXOR gate? Correct Answer y <= ((not a) AND b) OR (a AND (not b));

EXOR function or Exclusive OR is a function in which two inputs of the gate can’t be at high level exclusively, in that case the output will be low. It is described by Y = A’B + AB’. This function is described in the VHDL terms by using option d. Therefore, option d represents EXOR gate.

Related Questions

A universal logic gate is one which can be used to generate any logic function. Which of the following is a universal logic gate?
The input to a logic gate is A = 1100 and B = 1010. What will be the output, if the logic gate is NAND gate?
Consider the following sentences: (i) The number of candidates who appear for the GATE examination is staggering. (ii) A number of candidates from my class are appearing for the GATE examination. (iii) The number of candidates who appear for the GATE examination are staggering. (iv) A number of candidates from my class is appearing for the GATE examination. Which of the above sentences are grammatically CORRECT?
Consider the following statements regarding Thyristor: 1. It conducts when forward biased and positive current flows through the gate 2. It conducts when forward biased and negative current flows through the gate 3. It commutates when reverse biased and negative current flows through the gate 4. It commutates when the gate current is withdrawn Which of these statement(s) is/are correct?
একটি XOR লজিক গেট নিম্নলিখিত কোন লজিক গেট/ গেটগুলোর সমবায়ে গঠিত হতে পারে? (An XOR logic gate can be constructed from the combination of which of the following logic gate/gates?)
Dehli Gate, Nagauri Gate, Talaqi Gate and Mori Gate are located in which Fort of Haryana?
A state diagram of a logic gate which exhibits delay in the output is shown in the figure, where X is the don’t care condition and Q is the output representing the state The logic gate represented by the state diagram is
In which of the below-mentioned logic families, the transistors operate between cut-off and active (non-saturation) states? (i) Transistor-Transistor Logic (TTL) (ii) Schottky TTL (iii) Diode Transistor Logic (DTL) (iv) Emitter Coupled Logic (ECL) Choose the correct answer from the code given below: Code:
A tank of water has a gate in its vertical wall. The gate is 4 m high and 3 m wide. The top edge of the gate is 2 m below the surface of water. What is the hydrostatic force on the gate. Take specific weight of water as 10 kN/m3.
If VIL of the 2nd gate is higher than VOL of the 1st gate, then logic output 0 from the 1st gate is considered as: