Bissoy.com
Doctors Medicines MCQs Q&A

_______________ is a nut in which slots are cut in a cylindrical collar provided on the top of the nut, thus overcoming the disadvantage of slotted nut.

_______________ is a nut in which slots are cut in a cylindrical collar provided on the top of the nut, thus overcoming the disadvantage of slotted nut. Correct Answer Castle nut

Castle nut is a nut in which slots are cut in a cylindrical collar provided on the top of the nut, thus overcoming the disadvantage of slotted nut the nuts which are widely used in automobile and locomotive engines and also in steam engine.

Related Questions

A hexagonal nut with slots cut in the upper end of it and through opposite faces in which slotted pin is inserted is called _________ nut.
The nut which has a cylindrical grooved collar at its lower end and this collar fits into a corresponding recess in the adjoining piece is named as.
Assertion (A): Slotted armature type in this armature is placed in slotted armature with DC windings placed inside the slots. Reason (R): The construction is highly reliable and rugged but has high torque.
If joint is to fail by crushing of socket collar then estimate the diameter of socket collar. Given Permissible compressive stress= 126.67 N/mm².; Spigot dia=65mm; thickness 0f collar=15mm
A machine vice whose length of the handle is 150mm and the coefficient of friction for thread and collar are 0.15 and 0.17 respectively has a force applied at handle of 125N. Also the outer and inner diameters of collar are 55mm and 45mm respectively. Find the collar torque in terms of clamping force W assuming uniform wear theory if nominal diameter=22mm and pitch=5mm.
Last year, there were three sections in a competitive exam. Out of them 33 students cleared the cut-off in Section A, 34 students cleared the cut-off in Section B and 32 students cleared the cut-off in Section C. 10 students cleared the cut-off in section A and section B, 9 cleared the cut-off in section B and section C and 8 cleared the cut-off in section A and section C. The number of students who cleared only one section was equal and was 21 for each section. How many students cleared all the three sections?
_______________________ is a nut in which a collar is provided at the upper end of the hexagonal nut and a fiber ring is fitted inside it.
Directions : In each of the following questions a statement is given, followed by two conclusions. Give answer :

Statement : The General Administration Department has issued a circular to all the employees informing them that henceforth the employees can avail their lunch break at any of the half-hour slots between 1.00 p.m. and 2.30 p.m.

Assumptions :
I. The employees may welcome the decision and avail lunch break at different time's slots.
II. There may not be any break in the work of the organization as the employees will have their lunch break at different time slots.
A sphere of diameter 42 cm is melted and bullets are formed from it. The bullet has circular cylindrical shape from one side and conical from other side. The radius of the base of the cylindrical part of the bullet is 6 cm and the cylindrical part has thrice as much length as the conical part. Find how many such bullets can be formed if the curved surface area of the cylindrical part of a bullet is 79.2 cm2.
____________________ roof is similar to the collar beam roof accept that two collar beams which are crossing each other to present an appearance of scissors are provided.