Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Below are the two ensemble models: 1. E1(M1, M2, M3) and 2. E2(M4, M5, M6) Above, Mx is the individual base models. Which of the following are more likely to choose if following conditions for E1 and E2 are given? E1: Individual Models accuracies are high but models are of the same type or in another term less diverse E2: Individual Models accuracies are high but they are of different types in another term high diverse in nature
Regarding bias and variance, which of the following statements are true? (Here 'high' and 'low' are relative to the ideal model.
i. Models which overfit are more likely to have high bias
ii. Models which overfit are more likely to have low bias
iii. Models which overfit are more likely to have high variance
iv. Models which overfit are more likely to have low variance
Regarding bias and variance, which of the following statements are true? (Here 'high' and 'low' are relative to the ideal model. (i) Models which overfit are more likely to have high bias (ii) Models which overfit are more likely to have low bias (iii) Models which overfit are more likely to have high variance (iv) Models which overfit are more likely to have low variance
Generally, tortuous liability has an element of fault to support it. In which one of the following Acts, recently a provision has been made in India, which provides for meeting claims arising both on the basis of fault principle and no fault principle?
The following question has three statements. Study the question and the statements to decide which of the statement(s) is/are necessary to answer the question. A train starts from point A towards point B, but after ‘n’ hours, its speed becomes 2/3rd of the normal speed due to some fault. Find the value of n. Statement I: The fault occurred at a distance of 800 km from the destination Statement II: Had the fault occurred 200 km further, the train would have got late by 30 min Statement III: The train got late by 40 min
The fault which is the result of both fault scarps and fault-line scarps is?
A sustained three phase fault occurs in the power system shown in the figure. The current and voltage phasors during the fault (on a common reference), after the natural transients have died down, are also shown. Where is the fault located?  
Three – phase to ground fault takes place at locations F1 and F2 in the system shown in the figure If the fault takes place at location F1, then the voltage and the current at bus A are VF1 and IF1 respectively. If the fault takes place at location F2, then the voltage and the current at bus A are VF2 and IF2 respectively. The correct statement about voltages and currents during faults at F1 and F2 is
Calculate the value of the fault impedance if the fault voltage is 2 V and fault current is 4 A.
The fault not belonging to the classification of fault with the attitude of fault as basis ___________