Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

For transistor action (a) Base, emitter, and collector regions should have similar size and doping concentrations. (b) The base region must be very thin and lightly doped. (c) The emitter-base junction is forward biased and the base-collector junction is reverse biased. (d) Both the emitter-base junction as well as the base-collector junction are forward biased. Which one of the following pairs of statements is correct?
For a narrow base PNP BJT, the excess minority carrier concentrations (ΔnE for emitter, ΔpB for base, ΔnC for collector) normalized to equilibrium minority carrier concentrations (nE0 for emitter, pB0 for base, nC0 for collector) in the quasi-neutral emitter, base and collector regions are shown below. Which one of the following biasing modes is the transistor operating in?
A transistor is used in common emitter mode as an amplifier. Then a. The base-emitter junction is forward biased b. The base-emitter junction is reverse biased  c. The input signal is connected in series with the voltage applied to the base-emitter junction  d. The input signal is connected in series with the voltage applied to bias the base-collector junction Which of the following statement is true?
Choose the right option among the alternatives – A transistor conducts in its forward direction when its collector/emitter/base, is positive with respect to its collector/emitter/base, and when a turn-on voltage or current signal is applied to its collector/emitter/base.
In a uniformly doped BJT, assume that NE, NB and NC are the emitter, base and collector doping in atoms/cm3, respectively. If the emitter injection efficiency of the BJT is close to unity, which one of the following conditions is TRUE?
Choose the correct statement(s) i) The gate circuit impedance of MOSFET is higher than that of a BJT ii) The gate circuit impedance of MOSFET is lower than that of a BJT iii) The MOSFET has higher switching losses than that of a BJT iv) The MOSFET has lower switching losses than that of a BJT
In a BJT, if the collector-base junction is reverse-biased and the base-emitter junction is forward-biased, which region is the BJT operating in?
In a BJT, if the collector-base junction is forward-biased and the base-emitter junction is forward-biased, which region is the BJT operating in?
In a BJT, if the collector-base junction and the base-emitter junction are both reverse-biased, which region is the BJT operating in?
Which of the following conditions must be satisfied for a transistor to be in saturation? 1. Its collector to base junction should be under forward bias 2. Its collector to base junction should be under reverse bias 3. Its emitter to base junction should be under reverse bias 4. Its emitter to base junction should be under forward bias Which of the above conditions are correct?