Bissoy.com
Doctors Medicines MCQs Q&A

In a Wien bridge oscillator, it is found that at the frequency ωO there is no phase shift in RF/R gain loop and the phase shift of the amplifier is also zero. Then what is the equation for the radian frequency, given R1, C1 is the series network of bridge and R2, C2 is the parallel network?

In a Wien bridge oscillator, it is found that at the frequency ωO there is no phase shift in RF/R gain loop and the phase shift of the amplifier is also zero. Then what is the equation for the radian frequency, given R1, C1 is the series network of bridge and R2, C2 is the parallel network? Correct Answer ωO=1/R1R2C1C2

For no phase shift for the amplifier, the frequency of the output is given by ωO = 1/R1R2C1C2 and RF/R = C1/C2 + R2/R1. When R1=R2 and C1=C2 then RF = 2R.

Related Questions

Consider the following statements related to oscillator circuits : 1. The tank circuit of a Hartley oscillator is made up of a tapped capacitor and a common inductor. 2. The tank circuit of a Colpitts oscillator is made up of a tapped capacitor and a common oscillator. 3. The Wien Bridge oscillator is essentially a two-stage amplifier with an RC bridge in the first stage, and, the second stage serving as an inverter. 4. Crystal oscillators are fixed frequency oscillators with a high Q-factor.  Which of the following are true?
For an RC phase shift oscillator, the following statements are cited: a) Amplifier gain is negative b) Phase shift introduced by the feedback circuit is either 0 or 360° c) Amplifier gain is positive d) Phase shift introduced by the feedback circuit is 180° Which of the following options is correct?
For any Wien Bridge oscillator, R1 = R2 and C1 = C2 always in the bridge, provided the phase shift through the amplifier is zero.
A certain inverting amplifier has a closed-loop voltage gain of 25. The OP-amp has an open-loop voltage gain of 100,000. If an OP-amp with an open-loop voltage gain of 200,000 is substituted in the arrangement, the closed-loop gain
The network formed by resistors and capacitors for modifying the rate of change of gain and the phase shift is called a compensating network. Which of the following statements are not correct ? (A) The main purpose of a compensating network is to modify the performance of op-amp ciruit over the desired frequency range (B) There are two types of op-amps : internally compensated and externally compensated (C) 741 C is an externally compensated op-amp while 709 C is internally compensated op-amp (D) The phase lag and phase lead are most commonly used compensating networks in op-amps (E) Phase lag contributes a positive phase angle and phase lead a negative phase angle Choose the most appropriate answer from the options given below : 
What do phase-shift oscillators, twin-T oscillators, and Wien bridge oscillators have in common? a. They use RC frequency control b. They have a sinusoidal output. c. They use amplifier gain to overcome feedback loss.
What will be oscillator frequency, if phase shift network of 3stages of RC phase shift oscillator contains a capacitor of 7nF and a resistance of 10K in each stage?
A particular op amp, characterized by a gain–bandwidth product of 20 MHz, is operated with a closed-loop gain of +100 V/V. What 3-dB bandwidth results? At what frequency does the closed-loop amplifier exhibit a −6° phase shift?
When a 1-phase transformer is connected in parallel, there are four conditions for proper parallel operation, but when two or 3-phase transformer paralleling is done, there are two additional points along with those four conditions applied for 1-phase. Statement 1 - The phase sequence must be the same. Statement 2 - The phase shift between primary and secondary voltages must be the same for all transformers connected in parallel. From the above two Statements (s), which is/are the correct conditions in this regard?
When we compare the half bridge converter and full bridge converter 1. The maximum collector current of a full bridge is only double that of the half bridge 2. Full bridge uses 4-power switches instead of 2, as in the double bridge. 3. Output power of a full bridge is twice that of a half bridge with the same input voltage and current. When of the above statements are correct?