Which of the following amplifier is designed to operate in digital pulses?

Which of the following amplifier is designed to operate in digital pulses? Correct Answer Class D

Class D amplifiers use a form of PWM to control the output devices. Conduction angle varies with the pulse width and doesn’t depend on the input directly. The analog signal is converted into a stream of pulses representing the signal using a modulation technique.
Bissoy MCQ

Related Questions

A source produces binary data at the rate of 10 kbps. The binary symbols are represented as shown in the figure.
Digital Communication mcq question image
The source output is transmitted using two modulation schemes, namely Binary PSK (BPSK) and Quadrature PSK (QPSK). Let and B2 be the bandwidth requirements of BPSK and QPSK respectively. Assuming that the bandwidth of the above rectangular pulses is 10 kHz, B1 and B2 are
In counterfort type retaining walls
i) the vertical slab is designed as a continuous slab
ii) the heel slab is designed as a continuous slab
iii) the vertical slab is designed as a cantilever
iv) the heel slab is designed as a cantilever
The correct answer is
Routers operate at layer _____. LAN switches operate at layer _____. Ethernet hubs operate at layer _____. Word processing operates at layer _____.
Routers operate at layer _____. LAN switches operate at layer ______. Ethernet hubs operate at layer _____. Word processing operates at layer _______.
Computers cannot communicate with each other directly over telephone lines because they use digital pulses whereas telephone lines use analog sound frequencies. What is the name of the device which permits digital to analog conversion at the start of a long distance transmission?
Digital camera signals transfer all analog signals into digital pulses.
A modulating signal is amplified by a 80% efficiency amplifier before being combined with a 20 kW carrier to generate an AM signal. The required DC input power to the amplifier, for the system to operate at 100% modulation, would be
Consider the amplifier below for the case VDD = 5 V, RD = 24 kΩ, (W/L) = 1 mA/V2, and Vt = 1 V. If the amplifier is biased to operate with an overdrive voltage VOV of 0.5 V, find the incremental gain at the bias point.
Consider the amplifier below for the case VDD = 5 V, RD = 24 kΩ, (W/L) = 1 mA/V2, and Vt = 1 V. For amplifier biased to operate with an overdrive voltage of 0.5V, and disregarding the distortion caused by the MOSFET’s square-law characteristic, what is the largest amplitude of a sine-wave voltage signal that can be applied at the input while the transistor remains in saturation?
A 50 Ω branch-line Quadrature hybrid has to be designed to operate over a range of frequencies. The branch-line impedance of this coupler so designed is: