Bissoy.com
Doctors Medicines MCQs Q&A

If peak voltage on a bridge full wave rectifier circuit is 5V and diode cut-in voltage is 0.7, then peak inverse voltage on diode will be _________

If peak voltage on a bridge full wave rectifier circuit is 5V and diode cut-in voltage is 0.7, then peak inverse voltage on diode will be _________ Correct Answer 4.3V

PIV is the maximum reveres bias voltage that can be appeared across a diode in the circuit. If PIV rating of the diode is less than this Value breakdown of diode may occur. Therefore, PIV rating of diode should be greater than PIV in the circuit. For bridge rectifier PIV is Vm-VD = 5-0.7=4.3.

Related Questions

When we compare the half bridge converter and full bridge converter 1. The maximum collector current of a full bridge is only double that of the half bridge 2. Full bridge uses 4-power switches instead of 2, as in the double bridge. 3. Output power of a full bridge is twice that of a half bridge with the same input voltage and current. When of the above statements are correct?
If peak voltage on a bridge full wave rectifier circuit is 5V and diode cut in voltage os 0.7, then the peak inverse voltage on diode will be_________
If peak voltage on a center tapped full wave rectifier circuit is 5V and diode cut-in voltage is 0.7, then peak inverse voltage on diode will be ___________
If the peak voltage on a centre tapped full wave rectifier circuit is 5V and diode cut in voltage is 0.7. The peak inverse voltage on diode is_________
If peak voltage for a half wave rectifier circuit is 5V and diode cut in voltage is 0.7, then peak inverse voltage on diode will be?
If peak voltage on a half wave rectifier circuit is 5V and diode cut-in voltage is 0.7, then peak inverse voltage on diode will be __________
Match the following: (i) Half wave rectifier p) Transformer not required (ii) Full wave rectifier  q) Centre tap transformer required (iii) Full wave bridge rectifier r) Ordinary transformer required
For a half wave or full wave rectifier the Peak Inverse Voltage of the rectifier is always
In a single-phase full-wave bridge circuit and in a three-phase, delta full-wave bridge circuit, what will be the ripple voltage frequency respectively?
Consider the following statements: 1. The voltage developed across the OFF switches of the half-bridge converter is the maximum dc-link voltage. 2. In the full-bridge converter, the voltage across the primary of the transformer is the dc link voltage. 3. The voltage developed across the OFF switches of the full-bridge converter is half the maximum dc-link voltage. Which of the above statements are correct?