Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Which of the following command options are displayed when you use the Router# show frame-relay ? command?
1. dlci
2. neighbors
3. lmi
4. pvc
5. map
Consider the following grammar G: P → Q + R | Q – R | Q | R Q → q | r R → r | s where P, Q, and R are non-terminal symbols, and q, r, and s are terminal symbols. Which of the following statement(s) is/are correct? S1. LL(1) can parse all strings that are generated using grammar G S2. LR(1) can parse all strings that are generated using grammar G
Consider the following grammar G S → F | H F → p | c H → d | c Where S, F, and H are non-terminal symbols, p, d, and c are terminal symbols. Which of the following statement(s) is/are correct? S1. LL(1) can parse all strings that are generated using grammar G S2. LR(1) can parse all string that are generated using grammar G
"BDL Ltd. is currently preparing its cash budget for the year to 31 March 20XX. An extract from its sales budget for the same year shows the following sales values.
Rs
March 60,000
April 70,000
May 55,000
June 65,000
40% of its sales are expected to be for cash. Of its credit sales, 70% are expected to pay in month after sale and take a 2% discount. 27% are expected to pay in the second month after the sale, and the remaining 3% are expected to be bad debts. The value of sales budget to be shown in the cash budget for May 20XX is"
Which of the following commands will display the current IP addressing and the layer 1 and 2 status of an interface?
1. show version
2. show protocols
3. show interfaces
4. show controllers
5. show ip interface
Which three commands can be used to check LAN connectivity problems on a router?
1. show interfaces
2. show ip route
3. tracert
4. ping
5. dns lookups
To enable EIGRP, which of the following would you use?
1. Router1(config-if)# ipv6 ospf 10 area 0.0.0.0
2. Router1(config-if)# ipv6 router rip 1
3. Router1(config)# ipv6 router eigrp 10
4. Router1(config-rtr)# no shutdown
5. Router1(config-if)# ipv6 eigrp 10
You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?
1. Switch (config-if) # ip access-group 10
2. Switch (config-if) # switchport port-security maximum 1
3. Switch (config) # access-list 10 permit ip host 1
4. Switch (config-if) # switchport port-security violation shutdown
5. Switch (config) # mac-address-table secure
Which two of the following commands will place network 10.2.3.0/24 into area 0?
1. router eigrp 10
2. router ospf 10
3. network 10.0.0.0
4. network 10.2.3.0 0.0.0.255 area0
5. network 10.2.3.0 0.0.0.255 area 0
What two multicast addresses does OSPFv3 use?
1. FF02::A
2. FF02::9
3. FF02::5
4. FF02::6