Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

What is the normal order of activities in which traditional software testing is organized ? (a) Integration Testing (b) System Testing (c) Unit Testing (d) Validation Testing
Which of the following command options are displayed when you use the Router# show frame-relay ? command?
1. dlci
2. neighbors
3. lmi
4. pvc
5. map
Match the items of List - II with the items of List - I and select the code of correct matching List - I List - II (a) Chi-square Test (i) Testing the significance of the differences of the mean values among more than two sample groups. (b) ANOVA (F-test) (ii) Testing the goodness of fit of a distribution (c) Z - test (iii) Testing the significance of the difference of the mean values between two large sized samples (d) t - test (iv) Testing the significance of the difference of the mean values between two small sized samples when population standard deviation is not available  
Which of the following commands will display the current IP addressing and the layer 1 and 2 status of an interface?
1. show version
2. show protocols
3. show interfaces
4. show controllers
5. show ip interface
To enable EIGRP, which of the following would you use?
1. Router1(config-if)# ipv6 ospf 10 area 0.0.0.0
2. Router1(config-if)# ipv6 router rip 1
3. Router1(config)# ipv6 router eigrp 10
4. Router1(config-rtr)# no shutdown
5. Router1(config-if)# ipv6 eigrp 10
Which two of the following commands will place network 10.2.3.0/24 into area 0?
1. router eigrp 10
2. router ospf 10
3. network 10.0.0.0
4. network 10.2.3.0 0.0.0.255 area0
5. network 10.2.3.0 0.0.0.255 area 0
Which three commands can be used to check LAN connectivity problems on a router?
1. show interfaces
2. show ip route
3. tracert
4. ping
5. dns lookups
You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?
1. Switch (config-if) # ip access-group 10
2. Switch (config-if) # switchport port-security maximum 1
3. Switch (config) # access-list 10 permit ip host 1
4. Switch (config-if) # switchport port-security violation shutdown
5. Switch (config) # mac-address-table secure
Consider the following statements:
1. Section 34 of Indian Penal Code requires two persons whereas Section 149 of Indian Penal Code require five persons.
2. Section 34 of Indian Penal Code requires common intention, whereas Section 149 of Indian Penal Code requires common object
3. Section 34 of Indian Penal Code and Section 149 of Indian Penal Code both require presence of a prior consent
4. Section 34 of Indian Penal Code and section 149 of Indian Penal Code. Both create specific offence
Which of the above statements are correct?
Which of the following is/are behavioral testing technique(s) ? (A) Equivalence Partitioning (B) Graph-Based Teating Method (C) Boundery Value Analysis (D) Data flow Testing (E) Loop Testing Choose the correct answer from the options given below: