Which two commands are required for basic OSPF configuration? area ” and “Router ospf ” b) “ area ” and “ area ” c) Only “Router ospf ” d) “ area ” and “Router ospf ”

Which two commands are required for basic OSPF configuration? area ” and “Router ospf ” b) “ area ” and “ area ” c) Only “Router ospf ” d) “ area ” and “Router ospf ” Correct Answer Network mask

The “Router ospf ” command enables OSPF routing protocol in the router and the “ area ” command is used to select the interfaces that we want to include in the OSPF process. That is enough for the basic configuration of OSPF in a router.
Bissoy MCQ

Related Questions

Network 206.143.5.0 was assigned to the Acme Company to connect to its ISP. The administrator of Acme would like to configure one router with the commands to access the Internet. Which commands could be configured on the Gateway router to allow Internet access to the entire network?
1. Gateway (config) # ip route 0.0.0.0 0.0.0.0 206.143.5.2
2. Gateway (config) # router rip
3. Gateway (config-router) # network 206.143.5.0
4. Gateway (config-router) # network 206.143.5.0 default
Which of the following describe the process identifier that is used to run OSPF on a router?
1. It is locally significant.
2. It is globally significant.
3. It is needed to identify a unique instance of an OSPF database.
4. It is an optional parameter required only if multiple OSPF processes are running on the router.
You get a call from a network administrator who tells you that he typed the following into his router:
Router (config) #router ospf 1Router (config-router) #network 10.0.0.0 255.0.0.0 area 0
He tells you he still can't see any routes in the routing table. What configuration error did the administrator make?
An OSPF router receives an LSA, the router checks its sequence number, and this number matches the sequence number of the LSA that the receiving router already has. What does the receiving router do with the LSA?
A group of 2m - 1 routers are interconnected in a centralized binary tree, with router at each tree node. Router I communicate with router J by sending a message to the root of the tree. The root then sends the message back down to J. Then find the mean router-router path length.
Which two of the following commands will place network 10.2.3.0/24 into area 0?
1. router eigrp 10
2. router ospf 10
3. network 10.0.0.0
4. network 10.2.3.0 0.0.0.255 area0
5. network 10.2.3.0 0.0.0.255 area 0
You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?
The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?
An OSPF router receives an LSA. The router checks its sequence number and finds that this number is higher than the sequence number it already has. Which two tasks does the router perform with the LSA?
An OSPF router receives an LSA. The router checks its sequence number and finds that this number is lower than the sequence number it already has. What does the router do with the LSA?