Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Suppose a customer is planning to create a non-hosted Linux partition on an i825. Linux will have only direct-attach devices. What is the Linux console option?
P, Q, R, S, T and U are six persons who have different mobiles - Nokia, Vivo, Oppo, Samsung, Apple and Jio (but not necessarily in the same order). P does not have Apple mobile. U does not have Oppo nor Vivo mobile. T has a Nokia mobile. R does not have Oppo nor Apple mobile. Q does not have Samsung nor Oppo mobile. P does not have Oppo nor Jio mobile. U does not have Jio nor Apple mobile. Which of the following combinations is correct?
Which of the following command options are displayed when you use the Router# show frame-relay ? command?
1. dlci
2. neighbors
3. lmi
4. pvc
5. map
Linux does not have code editor . . . . . . . .
Which of the following commands will display the current IP addressing and the layer 1 and 2 status of an interface?
1. show version
2. show protocols
3. show interfaces
4. show controllers
5. show ip interface
Which three commands can be used to check LAN connectivity problems on a router?
1. show interfaces
2. show ip route
3. tracert
4. ping
5. dns lookups
To enable EIGRP, which of the following would you use?
1. Router1(config-if)# ipv6 ospf 10 area 0.0.0.0
2. Router1(config-if)# ipv6 router rip 1
3. Router1(config)# ipv6 router eigrp 10
4. Router1(config-rtr)# no shutdown
5. Router1(config-if)# ipv6 eigrp 10
You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?
1. Switch (config-if) # ip access-group 10
2. Switch (config-if) # switchport port-security maximum 1
3. Switch (config) # access-list 10 permit ip host 1
4. Switch (config-if) # switchport port-security violation shutdown
5. Switch (config) # mac-address-table secure
Which two of the following commands will place network 10.2.3.0/24 into area 0?
1. router eigrp 10
2. router ospf 10
3. network 10.0.0.0
4. network 10.2.3.0 0.0.0.255 area0
5. network 10.2.3.0 0.0.0.255 area 0
Which shortcut does sed offer to replace the string Linux with Red hat Linux?