Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Seven people A, B, C, D, E, F and G live on separate floors of a 7-floor building. Ground floor is numbered 1, first floor is numbered. 2 and so on until the topmost floor is numbered 7. Each one of these having a different cars-Cadillac, Ambassador, Fiat, Maruti, Mercedes, Bedford and Fargo but not necessarily in the same order. Only three people live above the floor on which A lives. Only one person lives between A and the one having a car Cadillac. F lives immediately below the one having a car Bedford. The one having a car Bedford lives on an even-numbered floor. Only three people live between the ones having a car Cadillac and Maruti. E lives immediately above C. E is not having a car Maruti. Only two people live between B and the one having a car Fargo. The one having a car Fargo lives below the floor on which B lives. The one having a car Fiat does not live immediately above D or immediately below B. D does not live immediately above or immediately below A. G does not have a car Ambassador. Question : How many people live between the floors on which D and the one having a car Bedford ?
A resistance R is measured using the connection shown in the below figure. The current measured is 10 A on ranges 100A and the voltage measured is 125 V on 150 V range. The scales of the ammeter and voltmeter are uniform. The total number of scale divisions of the ammeter is 100 and that of the voltmeter is 150. The scale division can be distinguished. The constructional error of the ammeter is ± 0.3% and that of voltmeter±0.4%. The resistance of the ammeter is 0.25 Ω. The possible error in the measurement of R is?
If X is the MTBF of a system and Y is the failure rate of the system then which one is true?
A system has MTBF of 100,000 hours and MTTR of 30 minutes. What is the average down time of the system in one year?
Two sides of a rectangle were measured. One of the sides (length) was measured 10% more than its actual length and the other side (width) was measured 5% less than its actual length. The percentage error in measure obtained for the area of the rectangle is :
Which of the following is not the best MTBF for a newly purchased laptop?
Which of the following is the abbreviation of MTBF?
The MTBF of system should be high for fault tolerant systems with
What is the full from of MTBF?
What is the MTBF of a solid state rate gyro?