Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Which of the following commands will display the current IP addressing and the layer 1 and 2 status of an interface?
1. show version
2. show protocols
3. show interfaces
4. show controllers
5. show ip interface
Which three commands can be used to check LAN connectivity problems on a router?
1. show interfaces
2. show ip route
3. tracert
4. ping
5. dns lookups
Which of the following command options are displayed when you use the Router# show frame-relay ? command?
1. dlci
2. neighbors
3. lmi
4. pvc
5. map
Which of the following statements are correct? 1. Pseudo instruction is a machine instruction. 2. A pseudo instruction is an instruction to the assembler. 3. The ORG (origin) is an example of pseudo instruction. 4. It is not possible to use ORG more than once in a program. Select the correct answer using the code given below.
What is linear_congruential_engine? for some w using Mersenne Twister algorithm b) Pseudo-random number engine that generates random unsigned integers c) Pseudo-random number engine that generates random unsigned integers in the range for some w using lagged Fibonacci generator d) Pseudo-random number engine that generates random signed integers in the range for some w using Mersenne Twister algorithm
The average weight of 20 contestants in a fashion show increased by 5.75 kg when one of the contestants left the show but when a new contestant joined the show then the average weight decreased by 2.75 kg. What is the difference between the weight of the new contestant who joined the show and the contestant who left the show?
Consider the following pseudo-code while (m < n) if (x > y) and (a < b) then a = a + 1 y = y - 1 end if m = m + 1 end while What is the cyclomatic complexity of the above pseudo-code?
To enable EIGRP, which of the following would you use?
1. Router1(config-if)# ipv6 ospf 10 area 0.0.0.0
2. Router1(config-if)# ipv6 router rip 1
3. Router1(config)# ipv6 router eigrp 10
4. Router1(config-rtr)# no shutdown
5. Router1(config-if)# ipv6 eigrp 10
You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?
1. Switch (config-if) # ip access-group 10
2. Switch (config-if) # switchport port-security maximum 1
3. Switch (config) # access-list 10 permit ip host 1
4. Switch (config-if) # switchport port-security violation shutdown
5. Switch (config) # mac-address-table secure
Which two of the following commands will place network 10.2.3.0/24 into area 0?
1. router eigrp 10
2. router ospf 10
3. network 10.0.0.0
4. network 10.2.3.0 0.0.0.255 area0
5. network 10.2.3.0 0.0.0.255 area 0