Bissoy.com
Doctors Medicines MCQs Q&A

The line of intersection formed is curve while two solids are intersecting the solids may be __________

The line of intersection formed is curve while two solids are intersecting the solids may be __________ Correct Answer cylinder, sphere

If any of the solid in two of intersecting solids is having curves surface that is cylinder, cone, sphere etc the line of intersection will give curve only but not straight line for getting line of intersection straight line both the solids should not have curved surfaces.

Related Questions

The line of intersection formed is straight line while two solids are intersecting the solids may be ________
The line of intersection formed is straight line while two solids are intersecting the solids may be ___________
The line of intersection formed is curve while two solids intersect the solids may be ____________
The line of intersection formed is straight line while two solids intersect the solids may be ___________
Drawing straight lines on both the surfaces of solids and then pointing the points where they intersect and drawing lines which forms the line of intersection this process of finding the line of intersection is termed as _______ method.
The MC curve reaches its minimum point before the AVC curve and the AC curve. In addition the MC curve intersects the AVC curve and the AC curve at their lowest point. The above statements are both true
Statement (I): Two  non-intersecting and non-parallel, i.e., non-coplanar, shafts connected by gears are called skew-bevel gears or spiral gears, and this type of gearing has a line contact the rotation of which about the axes generates the two hyperboloid pitch surfaces. Statement (II): A hyperboloid is a 3D surface formed by revolving a straight line about an axis (not in the same plane), such that every point on the line remains at a constant distance from the axis.
Steps are given to draw normal and tangent to an archemedian curve. Arrange the steps, if O is the center of curve and N is point on it. i. Through N, draw a line ST perpendicular to NM. ST is the tangent to the spiral. ii. Draw a line OM equal in length to the constant of the curve and perpendicular to NO. iii. Draw the line NM which is normal to the spiral. iv. Draw a line passing through the N and O which is radius vector.
Find the equation of a line formed by the two points P and Q. Where P is the intersection point of lines 6x – y = 1 and  x + y = 6. Where Q is the intersection point of lines 5x – 3y = -1 and 2x + 6y = -10?
From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.