Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

In comparing the operation of the half-controlled 2-pulse circuit with that of the fully-controlled circuit, which of the following statements are evident? 1. Since half the thyristors are replaced by diodes, a half-controlled converter costs less than a fully-controlled converter. 2. Due to the freewheeling action with a half-controlled bridge-circuit power factor is improved in half-controlled converters. 3. The AC supply current is more distorted due to its zero periods with the half-controlled circuit, compared to a fully-controlled bridge circuit. Select the correct answer using the code given below :
Consider the following statements (a) BJT is a current controlled device with high input impedance and high gain band width (b) FET is a voltage- controlled device with high input impedance and low gain bandwidth (c) UJT is a negative resistance device and can be used as an oscillator (d) FET and UJT can be used for amplification Which of the above statements are correct 
The parallel combination of a 6.8 kΩ resistor and a 10 kΩ resistor is in series with the parallel combination of a 2.2 kΩ resistor and a 1 kΩ resistor. A 100 V source is connected across the circuit. The resistor(s) with the greatest voltage drop is (are)
Two resistors are in series: a 5.6 kΩ resistor and a 4.7 kΩ resistor. The voltage drop across the 5.6 kΩ resistor is 10 V. The voltage across the 4.7 kΩ resistor is
A 12 kΩ resistor, a 15 kΩ resistor, and a 22 kΩ resistor are in series with two 10 kΩ resistors that are in parallel. The source voltage is 75 V. Current through the 15 kΩ resistor is approximately
Consider the following statements regarding a differential amplifier using an FET pair. The differential output offset voltage is due to: 1. Mismatch between FET parameters 2. Difference between the values of resistors used in the circuit even though they are marked nominally equal 3. Variation in the operating voltage of the circuit Which of the above statements are correct?
A 40 Ω resistor is in parallel with an 80 Ω resistor. Current in the 40 Ω resistor is 6 A. How will you add a third resistor and what will be its value if the line-current is to be 10 A?
A source maintains a current I in a resistor of resistor of resistance R. If V is the potential difference across the resistor. The electrical energy dissipated in the resistor in time is given _____
Four resistors are connected in parallel. Fifteen mA flows through resistor R. If the second resistor is 2R, the third resistor 3R, and the fourth resistor 4R, the total current in the circuit is
A certain series circuit consists of a $$\frac{1}{8}$$ W resistor, a $$\frac{1}{4}$$ W resistor and a $$\frac{1}{2}$$ W resistor. The total resistance is 1200 Ω. If each resistor is operating in the circuit at its maximum power dissipation, total current flow is