Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

The short circuit impedance is given by 18 ohm and the characteristic impedance is 50 ohm. Find the open circuit impedance.
In the following figure, the transmitter Tx sends a wideband modulated RF signal via a coaxial cable to the receiver Rx. The output impedance ZT of Tx, the characteristic impedance Z0 of the cable, and the input impedance ZR of Rx are all real. Which one of the following statements is TRUE about the distortion of the received signal due to impedance mismatch?
After conjugate impedance matching the input impedance used for matching after normalization was 1+j with the characteristic impedance of the transmission line being 100Ω, then the generator impedance must have been:
Two single phase transformers A and B are operating in parallel having different impedance and identical x/r ratio. Impedance of A is Za and impedance of B is Zb, both sharing a load of Sl. Then the load shared by transformer A is?
Two single phase transformers A and B are operating in parallel having different impedance and identical x/r ratio. Impedance of A is Za and impedance of B is Zb, both sharing a load of Sl. Then the load shared by transformer B is?
If the width of a parallel plate waveguide is 30 mm and the distance between the parallel pates is 5 mm, with an intrinsic impedance of 377Ω, then the characteristic impedance of the wave is:
Referring to the given circuit, determine VTH and RTH if a 68 Ω resistor is connected in parallel across R2 and R3.
Circuit Theorems and Conversions mcq question image
Choose the correct statement(s) i) The gate circuit impedance of MOSFET is higher than that of a BJT ii) The gate circuit impedance of MOSFET is lower than that of a BJT iii) The MOSFET has higher switching losses than that of a BJT iv) The MOSFET has lower switching losses than that of a BJT
In comparing the operation of the half-controlled 2-pulse circuit with that of the fully-controlled circuit, which of the following statements are evident? 1. Since half the thyristors are replaced by diodes, a half-controlled converter costs less than a fully-controlled converter. 2. Due to the freewheeling action with a half-controlled bridge-circuit power factor is improved in half-controlled converters. 3. The AC supply current is more distorted due to its zero periods with the half-controlled circuit, compared to a fully-controlled bridge circuit. Select the correct answer using the code given below :
Determine $${I_{\text{N}}}$$ for the circuit consisting of VS, R1, R2 and R3 shown in the given circuit.
Circuit Theorems and Conversions mcq question image