Bissoy.com
Doctors Medicines MCQs Q&A

Primary winding of a transformer ______________

Primary winding of a transformer ______________ Correct Answer Could either be a low voltage or high voltage winding

Primary winding used in a transformer, can be at higher or lower voltage potential, depending on the number of turns with secondary winding. For step up and step-down transformers primary winding will be at lower and higher potential respectively.

Related Questions

Consider the following given statements about auto-transformers and choose the one which is/are correct. 1. Auto-transformers require less copper as compared to a conventional,2 winding transformer of the same capacity. 2. Auto-transformers provide isolation between the primary and secondary windings. 3. Auto- transformer has less leakage reactance as compared to the conventional, 2 winding transformer of the same capacity.
Distributed winding is a type of winding in electrical machines where all the winding turns are arranged in a number of full pitches or fractional pitches. These coils are then placed in phase form or the commutator winding in slots spread around the periphery of the air gap. This type of winding used in
A 25 KVA transformer is constructed to a turns ratio of N1/N2 = 10. The impedance of primary winding is 3+j5 ohms and of secondary winding is 0.5+j0.8 ohms. What will be the impedance of transformer when referred to primary?
A 100 VA, 120/12 V transformer is to be connected so as to form a step-up transformer. A Primary voltage of 120 V is applied to the transformer. What is the secondary voltage of the transformer?
An ideal transformer is having 150 turns primary and 750 turns secondary. The primary coil is connected to a 240 V, 50 Hz source. The secondary winding supplies a load of 4 A at lagging power factor of 0.8. What is the power supplied by the transformer to the load?
A 3-phase, 4-pole alternator has 48 stator slots carrying a 3-phase distributed winding. Each coil of the winding is short chorded by one slot pitch. The winding factor is given by ______________
A 100/10, 50 VA double winding transformer is converted to 100/110 V auto transformer. tWhat will be the rating of auto transformer?
When the secondary winding of a current transformer is open-circuited with the primary winding energized.
If the secondary winding of a current transformer is opened when the primary winding is carrying current, then the following event occurs:
What is the turns ratio of a power transformer that shows 50 V at its secondary winding when you apply 150 V to its primary winding?