Bissoy.com
Doctors Medicines MCQs Q&A

Which of the following is not true about 8085 microprocessor?

Which of the following is not true about 8085 microprocessor? Correct Answer It is manufactured using PMOS technology

8085 microprocessor is manufactured using NMOS technology. PMOS technology is used in a 4004 microprocessors. NMOS technology is faster than PMOS technology.

Related Questions

Which of the following statements regarding interface circuit are correct? 1. Electrical buffering is needed when the peripheral operates at a different voltage or current to that on the microprocessor bus system or there are different ground references. 2. Timing control is needed when the data transfer rates of the peripheral and the microprocessor are different. 3. Changing the number of lines is needed when the codes used by the peripherals differ from those used by the microprocessor.
In 8085 microprocessor with memory-mapped I/O which of the following is true?
In 8085 microprocessor system with memory mapped I/O, which of the following is true?
Assuming LSB at 0 position and MSB at position 7, which bit positions are not used (undefined) in flag register of an 8085 microprocessor?
With reference to 8085 microprocessor, which of the following statements are correct? 1. The DAD instruction adds the contents of the specified register pair to the contents of the DE register pair 2. The program counter is an instruction pointer 3. Whenever an instruction uses the HL pointer, the addressing is called indirect addressing. 4. HL register pair is also called data pointer
In an 8085 microprocessor, which of the following is the highest priority interrupt?
Which of the following interrupts is non-maskable in 8085 microprocessor?
Consider the following statements regarding RESET instruction of 8085 microprocessor 1. PC contents become 0000H. 2. All interrupts are enabled. 3. RESET OUT pin is at logic 0. Which of the above statements is/are correct?
With reference to 8085 microprocessor, which of the following statements are correct? 1. INR is 1-byte instruction 2. OUT is 2-byte instruction 3. STA is 3-byte instruction
Consider the following interrupts for 8085 microprocessor: 1. INTR 2. RST 5.5 3. RST 6.5 4. RST 7.5 5. TRAP If the interrupt is to be non vectored to any memory location, then which of the above interrupts is/are correct?