Bissoy.com
Doctors Medicines MCQs Q&A

On which element of the Yagi-Uda Antenna is signal power applied/received?

On which element of the Yagi-Uda Antenna is signal power applied/received? Correct Answer Driven element

Yagi-Uda Antenna structure:

∴ Yagi – Uda Antenna has:

  • A Driven element that is used to apply/receive the signal power.
  • A reflector that is used to reflect the signal radiation towards the driven element and directions.
  • Directors that are used to increase the directivity of the Antenna.


Yagi-Uda Antenna is used earlier for TV reception and its frequency range is around 30 MHz to 3 GHz.

Related Questions

Consider the following statements regarding modulation : 1. The communication systems, where a weak signal is transmitted by the use of a modulation is essential in carrier signal. 2. When the frequency of the high frequency signal is varied in accordance with the intensity of the low-frequency weak signal, the modulation is said to be frequency modulation. 3. The process of recovering original baseband signal from the modulated signal is called phase modulation. Which of the above statements are correct ? 
A radio link has 15 W transmitter connected to an antenna of 2.5 m2 effective aperture at 5 GHz. The receiving antenna has an effective aperture of 0.5 m2 and is located at a 15 Km line of sight distance from transmitting antenna. Assuming lossless, matched antennas, the power delivered to the receiver is:
The rule of thumb for antenna diversity states that for an antenna separation of 10 wavelengths or more, there is a considerable probability for the diversity signal to be substantially decorrelated from the primary signal.
Consider the following solution to the producer-consumer synchronization problem. The shared buffer size is ?. Three semaphores empty, full and mutex are defined with respective initial values of 0, ? and 1. Semaphore empty denotes the number of available slots in the buffer, for the consumer to read from. Semaphore denotes the number of available slots in the buffer, for the producer to write to. The placeholder variables, denoted by P, Q, R, and S, in the code below can be assigned either empty or full. The valid semaphore operations are: wait ( ) and signal ( ). Producer: Consumer: do {         wait (P) ;         wait (mutex) ;         //Add item to buffer         signal (mutex) ;         signal (Q) ; } while (1) ; do {          wait (R) ;          wait (mutex) ;          //Consume item from buffer          signal (mutex) ;          signal (S) ; } while (1) ;   Which one of the following assignments to P, Q, R and S will yield the correct solution?
A rectangular pulse train s(t) as shown in the figure is convolved with the signal cos2(4π × 103t). The convolved signal will be a
Signal Processing mcq question image
Kritika once standing near the main gate of her building which is of 11 stories found the angle of elevation to be 30° to the top of the cable antenna which is fixed on her terrace. She moved 50m in a straight line parallel to her feet towards the antenna and she found that angle of elevation changed to 45°. Find the height of the antenna from the ground?
A rectangular horn antenna has an aperture area of 3λ × 2λ. If the aperture efficiency of an antenna is 90%, then the directivity of the antenna is:
The electrical size of antenna is increased by antenna array to avoid size lobes compared to single antenna.
In the generation of element geometries, if dx dy represents an area element in the real element and dεdη represents the corresponding area element in the master element, then what is the expression for Jacobian je?
If the power density at a given distance ‘R’ is one microwatt per square meter and the effective area of antenna is one square meter then the power captured by antenna is one microwatt.