Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

What are the steps required in sequence to solve a circuit using superposition theorem? (a) Select any one source and short circuit all other voltage sources. (b) Find out the current or voltage across the required element, due to the source under consideration. (c) Open all current sources, if the internal impedance is not known. If known replace them by their impedances. (d) Add all the individual effects produced by individual sources to obtain the total current in or across the voltage element. Code :
Which of the following statements is/are correct with respect to a Scott-connected transformer? I. It can do 3-phase to 2-phase conversion II. It can do 2-phase to 3-phase conversion III. It can do 2-phase to 4-phase conversion IV. It can do 3-phase to 4-phase conversion
A distribution feeder of 1 km length having resistance, but negligible reactance, is fed from both the ends by 400 V, 50 Hz balanced sources. Both voltage sources S1 and S2 are in phase. The feeder supplies concentrated loads of unity power factor as shown in the figure. The contributions of S1 and S2 in 100 A current supplied at location P respectively, are
Given below are certain statements regarding the average power dissipated in different types of circuits. Identify the correct option. A. Maximum power dissipation occurs in the case of the resistive circuit and when the LCR circuit is at resonance. B. In the case of a purely inductive circuit, no power is dissipated. C. In the case of the RC circuit, power is dissipated in resistor and capacitor both.
Read the passage carefully and choose the best answer to each question out of the four alternatives and click the button corresponding to it.
Modern civilisation is completely dependent on energy, which has therefore to be abundant and also economical. About 85% of the world's energy is supplied by oil, coal and natural gas while nuclear, hydro, wind and solar power and biomass supply the rest. Coal, nuclear and hydro are used primarily to generate electricity while natural gas is widely used for heating. Biomass is used both for heating and cooking. The wind and solar power is the future's hope as they are sustainable energy sources. Oil powers almost all machines that move and that makes oil uniquely versatile. Oil powered airplanes carry 500 people across the widest oceans at nearly the speed of sound. Oil powered machines produce and transport food. Oil powered machines are ubiquitous. Clearly, we live in the age of oil but it is drawing to a close. According to data available if oil production remains constant until it's gone, there is enough to last 42 years. Oil wells will produce less as they become depleted, which will make it impossible to keep production constant. Similarly natural gas and coal will last another 61 years and 133 years respectively. Naturally, as they become scarce, they become expensive, leading to a worldwide energy crisis. If we are to survive on this planet, we have to make a transition to sustainable energy sources. The transition may be willy-nilly or planned - the choice is ours. The dawning era of limited and expensive energy will be very difficult for everyone on earth but will be even more difficult if it is not anticipated. It is of utmost importance that the public and policymakers understand the global energy crisis and act in tandem to ensure that the species 'homo sapiens' does not become extinct. The energy sources of the future are
Consider the following statements: 1. The voltage developed across the OFF switches of the half-bridge converter is the maximum dc-link voltage. 2. In the full-bridge converter, the voltage across the primary of the transformer is the dc link voltage. 3. The voltage developed across the OFF switches of the full-bridge converter is half the maximum dc-link voltage. Which of the above statements are correct?
A 3-phase bridge converter is given a three-phase supply in the phase sequence R-Y-B. Let the neutral to R phase voltage be Vm sinωt. The first SCR (connected to R phase) is fired at an angle of 15°. What is the maximum value at the output terminals at this instant?
The network formed by resistors and capacitors for modifying the rate of change of gain and the phase shift is called a compensating network. Which of the following statements are not correct ? (A) The main purpose of a compensating network is to modify the performance of op-amp ciruit over the desired frequency range (B) There are two types of op-amps : internally compensated and externally compensated (C) 741 C is an externally compensated op-amp while 709 C is internally compensated op-amp (D) The phase lag and phase lead are most commonly used compensating networks in op-amps (E) Phase lag contributes a positive phase angle and phase lead a negative phase angle Choose the most appropriate answer from the options given below : 
The armature winding of a 2-pole, 3-phase alternator for each phase is distributed in a number of slots per phase. The RMS value of the voltage per phase is less than the RMS value of the voltage per coil multiplied by the number of coils in series because the _________
This mention statement is associated with “In any network containing more than one sources of e.m.f. the current in any branch is the algebraic sum of a number of individual currents (the number being equal to the number of sources of e.m.f.), each of which is due to separate action of each source of e.m.f., taken order, when the remaining sources of e.m.f. are replaced by conductors, the resistances of which are equal to the internal resistances of the respective sources”.