Bissoy.com
Doctors Medicines MCQs Q&A

Which of the following is a not a lateral load resisting system?

Which of the following is a not a lateral load resisting system? Correct Answer Tubes

Concepts:

The most common bracing methods for resisting lateral forces include moment frames, shear walls, and braced frames. These are vertical elements that transfer lateral loads, including wind, seismic forces, and stability forces through floor or roof diaphragms to the building’s foundation.

[ alt="F5 Chandramouli Madhuri 25.01.2022 D1" src="//storage.googleapis.com/tb-img/production/22/01/F5_Chandramouli_Madhuri_25.01.2022_D1.png" style="width: 449px; height: 479px;">

Related Questions

Consider the following statement: 1. Initial load tests and routine load tests are carried out on test piles and working Piles, respectively. 2. In a pile load test, the allowable load can be taken equal to half the ultimate load at which the total settlement amounts to one-tenth of the pile diameter. 3. In a pile load test, the allowable load can be taken equal to two-thirds of the total toad which causes a plastic settlement of 6 mm. Which of the above statements are correct?
Where a structural component or a system is providing lateral support to five or more walls or columns, the lateral load to be resisted may be taken as __________ of the total vertical load on the most heavily loaded wall or column in the group
Where a structural component or a system is providing lateral support to five or more walls or columns, the lateral load to be resisted may be taken as __________ of the total vertical load on the most heavily loaded wall or column in the group.
Consider the following statements for Euler’s equation to find the critical load of a column : 1. Critical load of a column is proportional to the flexural rigidity. 2. Critical load of a column depends upon yield stress. 3. Critical load of a column is inversely proportional to the length of the column. 4. Critical load of a column is inversely proportional to the square of the length of the column. Which of the above statements are correct?
Consider the following two statements regarding Bearing stiffeners provided at the location of a concentrated load: 1. Bearing stiffeners have to resist bearing and buckling loads. 2. Bearing area and the area resisting buckling load are the same. Which of the above statements is/are correct ?
In connection with inspection and testing of concrete structures as per IS 456:2000, while conducting load tests on flexural members, what is the load (L) and minimum duration of load application(T) on the structure? (Use notations as : DL : dead Load, IL : Imposed load)
What is the partial safety factor for dead load in combination of DL+LL+WL/EL for limit state of serviceability, where DL=Dead load, LL=imposed load , WL=wind load, EL=earthquake load ?
Calculate ultimate moment and shear of effective span is 30m, live load is 9kn/m, dead load excluding self weight is 2kn/m, load factors for dead load is 1.4 for live load is 1.6 cube strength of concrete fcu is 50n/mm2 cube strength at transfer is fci is 35n/mm2, tensile strength of concrete Ec is 34kn/mm2 loss ratio ɳ is 0.85 and 8mm diameter high tensile strength fpu is 1500n/mm2 are available for use and the modulus of elasticity of high tensile wires is 200kn/mm2?
According to the level of pressure applied, lateral earth pressure is classified into various types. Which of the following type of lateral earth pressure refers to the minimum pressure exerted by the soil on the retaining wall?
In testing a pile by load test, pile platform is loaded with one and half times the design load and a maximum settlement is noted. The load is gradually removed and the consequent rebound is measured. For a safe pile, the net settlement (i.e. total settlement minus rebound) per tonne of test load should not exceed