Bissoy.com
Doctors Medicines MCQs Q&A

What is the radial distance of a tooth from the pitch circle to the top of the tooth known as?

What is the radial distance of a tooth from the pitch circle to the top of the tooth known as? Correct Answer Addendum

Addendum: It is the radial distance of a tooth from the pitch circle to the top of the tooth.

Dedendum: It is the radial distance of a tooth from the pitch circle to the bottom of the tooth.

Pitch circle: It is an imaginary circle which by pure rolling action, would give the same motion as the actual gear.

Pitch circle diameter: It is the diameter of the pitch circle. The size of the gear is usually specified by the pitch circle diameter. It is also called as pitch diameter.

Module: It is the ratio of the pitch circle diameter in millimetres to the number of teeth.

Module, m = D / T

Related Questions

The radial distance of a tooth from the pitch circle to the top of the tooth is called
The addendum is the radial distance of tooth from the pitch circle to the top of the tooth.
Which of the following statements is/are true? A: If a circle is formed from a wire, which was initially in the shape of a semi-circle, then ratio of radius of circle and that of semi-circle will be 7: 11. B: If in a semi-circle of radius ‘r’, another semi-circle of radius ‘4r/5’ is drawn, then area of the remaining part of larger semi-circle will be ‘3πr2/5’. C: In a circle of radius ‘r’, if ‘O’ is the center of circle and radii OA and OB are at the angle of 45°, then the length of major arc AB will be ‘7πr/8’.
The radial distance of a tooth from the pitch circle to the bottom of the tooth is called
The radial distance of a tooth from the pitch circle to the bottom of the tooth, is called
Radial distance between the pitch circle and the top of the tooth is known as
Consider the following statements regarding gear tooth designing for gear drive: 1. Tooth profiles not designed as per ‘law of gearing’ will cause vibration and impact problems even at low speed. 2. As the gears go through their mesh, the pitch point must remain stationary on the line of centres. 3. In a correctly designed tooth profile, the line of action of successive instantaneous points of contact will pass through the stationary pitch point. Which of the above statements are correct?
That surface of the tooth which is between the pitch circle and the top of the tooth is known as
Distance measured along the circumference of pitch circle from a point on tooth to the corresponding point on adjacent tooth is known as
The radial distance from the top of a tooth to the bottom of a tooth in a meshing gear, is called