Test my Merit My Results Create Exam

Higher Study | Design of Steel Structures | Structural Fasteners

Maximum size of a fillet weld for a plate of square edge is
For a laced column, the minimum width of the lacing bars when using 20 mm nominal diameter rivets is
When the maximum distance between centres of two adjacent rivets connecting the members subjected to either compression or tension exceed the maximum pitch, then the additional rivets which are not subjected to the calculated stress are used, and are known as 
When steel beam is connected to steel column by clest angles on either side of web of beam, the connection is known as
Hanger connections are made when
An angle ISA 50 × 50 × 6 is connected to a gusset plate 5 mm thick, with 16 mm bolts. What is the bearing strength of the bolt when the hole diameter is 16 mm and the allowable bearing stress is 250 MPa?
When a structure is designed by working stress method, the maximum stress that is permitted to be experienced in elements, members or structures under nominal loading is called: 
As per ‘Indian Standard General Construction in Steel- Code of practice’ for deep penetration welds, where the depth of penetration beyond the root run is a minimum of 2.4 mm, the size of fillet should be as:
The distance between center of fasteners shall not be less than Y times the nominal diameter of the fastener, where Y is:
Two 16 mm thick main plates are joined by rivets using the double cover butt joint with 10 mm thick cover plates as shown in figure. Bearing failure will occur first in
For the fillet weld cross – section shown in figure the throat thickness is:
As per IS: 800-1984 specification, how to calculate the gross diameter of a rivet? (If diameter of the rivet is less than or equal to 25 mm.)
If the ISA 100 × 65 × 8 is used for tension member, with 100 mm leg as the connected leg using a welded connection. What will be the shear lag width?
What will be the value of bolt hole diameter for 12 mm diameter bolt as per IS 800-2007?
As per Unwin’s formula, if t is the thickness of the plate in mm, what will be the nominal diameter of the rivet?
Ads