jH factor for heat transfer depends upon the __________ number.?

Biot
Nusselt
Reynolds
Prandtl

LohaHridoy

7 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

7 views Answered 2022-09-01 13:21

Related Questions

A heat exchanger with heat transfer surface area A and overall heat transfer coefficient U handles two fluids of heat capacities Cmax and Cmin. The number of transfer units (NTU) used in the analysis of heat exchanger is specified as?

1 Answers 7 Views

A cube at high temperature is immersed in a constant temperature bath. It loses heat from its top, bottom and side surfaces with heat transfer coefficients of h₁, h₂ and h₃ respectively. The average heat transfer coefficient for the cube is?

1 Answers 32 Views

If a heat transfer surface is pock-marked with a number of cavities, then as compared to a smooth surface the heat transfer by __________ will not increase.?

1 Answers 5 Views

Heat transfer by conduction results due to the transfer of free electrons, kinetic energy & vibrational energy from one molecule to another. Conduction heat transfer can not take place?

1 Answers 12 Views

The average heat transfer co-efficient over the entire length of the plate (ha) and the local heat transfer co-efficient (hL), in case of heat transfer over a flat plate in lminar zone is related as?

1 Answers 5 Views

For turbulent flow in a tube, the heat transfer co-efficient is obtained from the Dittus-Boelter correlation. If the tube diameter is halved and the flow rate is doubled, then the heat transfer co-efficient will change by a factor of?

1 Answers 6 Views

Extended heat transfer surface like fins are used to increase the heat transfer rate. Fin efficiency is defined as the ratio of heat transferred across the fin surface to the theoretical heat transfer across an equal area held at the?

1 Answers 5 Views

For shell and tube heat exchanger, with increasing heat transfer area, the purchased cost per unit heat transfer area?

1 Answers 5 Views

Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is?

1 Answers 5 Views

Factor of safety (i.e., overdesign factor) in heat transfer equipments is about __________ percent more than the actual/theoretical design factor.?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)