A cube at high temperature is immersed in a constant temperature bath. It loses heat from its top, bottom and side surfaces with heat transfer coefficients of h₁, h₂ and h₃ respectively. The average heat transfer coefficient for the cube is?

h₁ + h₂ + h₃
(h₁.h₂.h₃)1/3
1/h₁ + 1/h₂ + 1/h₃
None of these

LohaHridoy

32 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

A cube at high temperature is immersed in a constant temperature bath. It loses heat from its top, bottom and side surfaces with heat transfer coefficients of h₁, h₂ and h₃ respectively. The average heat transfer coefficient for the cube is 1/h₁ + 1/h₂ + 1/h₃

32 views Answered 2022-09-01 13:21

Related Questions

In the design of a front counterfort in a counterfort retaining wall, the main reinforcement is provided oni) bottom face near counterfortii) top face near counterfortiii) bottom face near centre of spaniv) top face near centre of span The correct answer is?

1 Answers 6 Views

According to Regnault's law, the specific heat at constant pressure (cp) and specific heat at constant volume (cv) _________ with the change in pressure and temperature of the gas.?

1 Answers 7 Views

The concept of overall coefficient of heat transfer is used in case of heat transfer by?

1 Answers 5 Views

The concept of overall coefficient of heat transfer is used in heat transfer problems of?

1 Answers 5 Views

A heat exchanger with heat transfer surface area A and overall heat transfer coefficient U handles two fluids of heat capacities Cmax and Cmin. The number of transfer units (NTU) used in the analysis of heat exchanger is specified as?

1 Answers 7 Views

For a laminar flow of fluid in a circular tube, 'h₁' is the convective heat transfer co-efficient at velocity 'V₁'. If the velocity is reduced by half and assuming the fluid properties are constant, the new convective heat transfer co-efficient is?

1 Answers 8 Views

If average heat transfer co-efficient is ha and the local coefficient at the end of the plate is hl then in case of heat transfer to a fluid flowing over a flat plate, heated over its entire length?

1 Answers 5 Views

The average heat transfer co-efficient over the entire length of the plate (ha) and the local heat transfer co-efficient (hL), in case of heat transfer over a flat plate in lminar zone is related as?

1 Answers 5 Views

Extended heat transfer surface like fins are used to increase the heat transfer rate. Fin efficiency is defined as the ratio of heat transferred across the fin surface to the theoretical heat transfer across an equal area held at the?

1 Answers 5 Views

Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)