Compound having large heat of formation is?

More stable
Less stable
Not at all stable (like nascent O₂)
Either more or less stable ; depends on the compound

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 1

Compound having high heat of formation indicates a higher amount of energy is released during the formation of compound so the compound formed will have lower energy hence it will be more stable.

4 views Answered 2022-09-01 13:21

Related Questions

A heat exchanger with heat transfer surface area A and overall heat transfer coefficient U handles two fluids of heat capacities Cmax and Cmin. The number of transfer units (NTU) used in the analysis of heat exchanger is specified as?

1 Answers 7 Views

A cube at high temperature is immersed in a constant temperature bath. It loses heat from its top, bottom and side surfaces with heat transfer coefficients of h₁, h₂ and h₃ respectively. The average heat transfer coefficient for the cube is?

1 Answers 32 Views

The amount of heat required to decompose a compound into its elements is __________ the heat of formation of that compound from its elements.?

1 Answers 5 Views

Heat requirement for decomposition of a compound into its elements is __________ that is evolved during the formation of that compound from its elements.?

1 Answers 4 Views

For large heat transfer area requirement, shell and tube heat exchanger is preferred, because it?

1 Answers 7 Views

The average heat transfer co-efficient over the entire length of the plate (ha) and the local heat transfer co-efficient (hL), in case of heat transfer over a flat plate in lminar zone is related as?

1 Answers 5 Views

A concentric double pipe heat exchanger as compared to the shell and tube heat exchanger for the same heat load requires?

1 Answers 4 Views

Extended heat transfer surface like fins are used to increase the heat transfer rate. Fin efficiency is defined as the ratio of heat transferred across the fin surface to the theoretical heat transfer across an equal area held at the?

1 Answers 5 Views

For shell and tube heat exchanger, with increasing heat transfer area, the purchased cost per unit heat transfer area?

1 Answers 5 Views

Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)