In multipass welds, shot peening is done after each pass to?

Close the surface porosity
Break the continuity of columnar grains
Flatten the weldment
Introduce texture in the weld

LohaHridoy

8 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 1

8 views Answered 2022-09-01 13:21

Related Questions

Transverse fillet welds are designed for?

1 Answers 4 Views

Mechanism/phenomenon involved in the improvement of fatigue strength of a material by shot peening is the?

1 Answers 5 Views

In a multipass shell and tube heat exchanger, tube side return pressure loss is equal to __________ the velocity head.?

1 Answers 17 Views

In case of a multipass shell and tube heat exchanger, the temperature drop in the fluid?

1 Answers 5 Views

In case of a multipass shell and tube heat exchanger, providing a baffle on the shell side __________ the heat transfer rate.?

1 Answers 8 Views

The ratio of velocity head to tube side return loss in case of a multipass shell and tube heat exchanger is?

1 Answers 27 Views

Multipass heat exchangers are used?

1 Answers 5 Views

'Fouling factor' used in the design of a multipass shell and tube heat exchanger is a?

1 Answers 10 Views

For the same heat load and mass flow rate in the tube side of a shell and tube heat exchanger, one may use multipass on the tube side, because it?

1 Answers 18 Views

For a multipass shell and tube heat exchanger, the LMTD correction factor is always?

1 Answers 6 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)