'Fouling factor' used in the design of a multipass shell and tube heat exchanger is a?

Non-dimensional factor
Factor of safety
Conversion factor for individual film heat transfer co-efficient to overall heat transfer co-efficient
None of these

LohaHridoy

10 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

10 views Answered 2022-09-01 13:21

Related Questions

In a multipass shell and tube heat exchanger, tube side return pressure loss is equal to __________ the velocity head.?

1 Answers 17 Views

In a shell and tube heat exchanger, putting a longitudinal baffle across the shell, forces the shell side fluid to pass __________ through the heat exchanger.?

1 Answers 4 Views

In case of a multipass shell and tube heat exchanger, providing a baffle on the shell side __________ the heat transfer rate.?

1 Answers 8 Views

The ratio of velocity head to tube side return loss in case of a multipass shell and tube heat exchanger is?

1 Answers 27 Views

For the same heat load and mass flow rate in the tube side of a shell and tube heat exchanger, one may use multipass on the tube side, because it?

1 Answers 18 Views

For a multipass shell and tube heat exchanger, the LMTD correction factor is always?

1 Answers 6 Views

Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is?

1 Answers 5 Views

In a multipass shell and tube heat exchanger, the problem of differential expansion between the shell and tube passes is taken care of by using a?

1 Answers 6 Views

In a multipass shell and tube heat exchanger, the shell side cross flow area does not depend upon?

1 Answers 5 Views

In a multipass shell and tube heat exchanger, the baffles on shell side is primarily provided for?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)