Rocks formed due to alteration of original structure due to heat and excessive pressure are called?

Sedimentary rocks
Igneous rocks
Metamorphic rocks
None of these

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

5 views Answered 2022-09-01 13:21

Related Questions

In a furnace, the heat taken by the charge/stock and the heat lost to the furnace structure & flue gases depends on the?

1 Answers 4 Views

According to Regnault's law, the specific heat at constant pressure (cp) and specific heat at constant volume (cv) _________ with the change in pressure and temperature of the gas.?

1 Answers 7 Views

A heat exchanger with heat transfer surface area A and overall heat transfer coefficient U handles two fluids of heat capacities Cmax and Cmin. The number of transfer units (NTU) used in the analysis of heat exchanger is specified as?

1 Answers 7 Views

A cube at high temperature is immersed in a constant temperature bath. It loses heat from its top, bottom and side surfaces with heat transfer coefficients of h₁, h₂ and h₃ respectively. The average heat transfer coefficient for the cube is?

1 Answers 32 Views

The device attached to the steam chest for preventing explosions due to excessive internal pressure of steam is called?

1 Answers 6 Views

The rate of Alteration of pressure filters is?

1 Answers 4 Views

Thermal pollution due to excessive heat & temperature in the working place causes?

1 Answers 5 Views

The average heat transfer co-efficient over the entire length of the plate (ha) and the local heat transfer co-efficient (hL), in case of heat transfer over a flat plate in lminar zone is related as?

1 Answers 5 Views

Extended heat transfer surface like fins are used to increase the heat transfer rate. Fin efficiency is defined as the ratio of heat transferred across the fin surface to the theoretical heat transfer across an equal area held at the?

1 Answers 5 Views

Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)