The maximum slenderness ratio of a compression member carrying both dead and superimposed load is?

180
200
250
350

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 1

4 views Answered 2022-09-01 13:21

Related Questions

The load factors for live load and dead load are taken respectively as?

1 Answers 6 Views

Assertion A : The load factor for live load is greater than that for dead load.Reason R : The live loads are more uncertain than dead loads.Select your answer based on the coding system given below :?

1 Answers 6 Views

The simply supported beam 'A' of length '$$l$$' carries a central point load 'W'. Another beam 'B' is loaded with a uniformly distributed load such that the total load on the beam is 'W'. The ratio of maximum deflections between beams 'A' and 'B' is?

1 Answers 5 Views

In this type of concrete, the steel is pre-tensioned before the superimposed load is applied:?

1 Answers 4 Views

In n₁ and n₂ are the indices of compression for the first and second stage of compression, then the ratio of work-done on the first and second stages (W₁/W₂) with perfect intercooling is given by?

1 Answers 5 Views

In a pre-stressed beam carrying an external load W with a bent tendon is having angle of inclination and pre-stressed load P. The net downward load at the centre is?

1 Answers 5 Views

If l₁ and l₂ are the lengths of long and short spans of a two way slab simply supported on four edges and carrying a load w per unit area, the ratio of the loads split into w₁ and w₂ acting on strips parallel to l₂ and l₁ is?

1 Answers 9 Views

For a circular slab carrying a uniformly distributed load, the ratio of the maximum negative to maximum positive radial moment, is?

1 Answers 5 Views

In testing a pile by load test, pile platform is loaded with one and half times the design load and a maximum settlement is noted. The load is gradually removed and the consequent rebound is measured. For a safe pile, the net settlement (i.e. total settlement minus rebound) per tonne of test load should not exceed?

1 Answers 5 Views

Assertion A : From consideration of structural soundness and economy of design, most codes control the maximum slenderness ratio of masonry walls and columns.Reason R : By controlling the maximum slenderness ratio, failure is by excessive stress and not by buckling. Select your answer according to codes given below:?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)