In the case of panel wall subjected to horizontal loads at right angles to the plane of the wall, with the mortar not leaner than Ml type, tensile stress in bending in the vertical direction may be allowed to the extent of?

0.4 kg/cm²
0.7 kg/cm²
1.0 kg/cm²
1.2 kg/cm²

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

5 views Answered 2022-09-01 13:21

Related Questions

A shaft of diameter D is subjected to a twisting moment (T) and a bending moment (M). If the maximum bending stress is equal to maximum shear stress developed, then M is equal to?

1 Answers 4 Views

A body is subjected to a direct tensile stress (σ) in one plane. The shear stress is maximum at a section inclined at __________ to the normal of the section.?

1 Answers 4 Views

In a simple bending theory, one of the assumptions is that the plane sections before bending remain plane after bending. This assumption means that?

1 Answers 4 Views

Every direct stress is always accompanied by a strain in its own direction and an opposite kind of strain in every direction, at right angles to it. Such a strain is known as?

1 Answers 5 Views

The velocity ratio in case of an inclined plane inclined at angle 'θ' to the horizontal and weight being pulled up the inclined plane by vertical effort is?

1 Answers 5 Views

A shaft is subjected to bending moment M and a torque T simultaneously. The ratio of the maximum bending stress to maximum shear stress developed in the shaft, is?

1 Answers 5 Views

If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span of a square flat slab, should not be less than?

1 Answers 5 Views

If p₁ and p₂ are effective lateral loadings at the bottom and top exerted by a level earth subjected to a super-load on the vertical face of height h of a retaining wall, the horizontal pressure p per unit length of the wall, is?

1 Answers 4 Views

The bending stress in a wall or column subjected to effective vertical load need not be considered, if the eccentricity ratio is?

1 Answers 4 Views

Assertion A : For identical strength, a composite cement-lime mortar is preferred over cement mortar.Reason R : Composite cement-lime mortar has higher drying shrinkage than cement mortar.Select your answer based on the codes given below. Codes:?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)