If Sb, is the average bond stress on a bar of diameter ‘d’ subjected to maximum stress ‘t’, the length of the embedment ‘l’ is given by?

l = dt/Sb
l = dt/2Sb
l = dt/3Sb
l = dt/4Sb

LohaHridoy

8 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 4

8 views Answered 2022-09-01 13:21

Related Questions

A double fillet welded joint with parallel fillet weld of length '$$l$$' and leg 's' is subjected to a tensile force 'P'. Assuming uniform stress distribution, the shear stress in the weld is given by?

1 Answers 5 Views

A closely coiled helical spring is acted upon by an axial force. The maximum shear stress developed in the spring is $$\tau $$. The half of the length of the spring if cut off and the remaining spring is acted upon by the same axial force. The maximum shear stress in the spring in new condition will be?

1 Answers 5 Views

The maximum stress due to stress concentration in a bar having circular transverse hole, as compared to its static stress without hole will be?

1 Answers 8 Views

A shaft of diameter D is subjected to a twisting moment (T) and a bending moment (M). If the maximum bending stress is equal to maximum shear stress developed, then M is equal to?

1 Answers 4 Views

The strain energy stored in a hollow circular shaft of outer diameter (D) and inner diameter (d) subjected to shear stress is?

1 Answers 4 Views

A thin cylindrical shell of diameter (d), length ($$l$$) and thickness (t) is subjected to an internal pressure (p). The hoop stress in the shell is?

1 Answers 5 Views

A shaft is subjected to bending moment M and a torque T simultaneously. The ratio of the maximum bending stress to maximum shear stress developed in the shaft, is?

1 Answers 5 Views

The length of the lap in a compression member is kept greater than bar diameter x (Permissible stress in bar / Five times the bond stress) or?

1 Answers 5 Views

If d is the diameter of a bar, ft is allowable tensile stress and fb, is allowable bond stress, the bond length is given by?

1 Answers 4 Views

The length of lap in tension reinforcement should not be less than the bar diameter × (actual tension / four times the permissible average bond stress) if it is more than?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)