The length of the lap in a compression member is kept greater than bar diameter x (Permissible stress in bar / Five times the bond stress) or?

12 bar diameters
18 bar diameters
24 bar diameters
30 bar diameters

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

5 views Answered 2022-09-01 13:21

Related Questions

The length of double bond is _______ than single bond.?

1 Answers 5 Views

In working stress design, permissible bond stress in the case of deformed bars is more than that in plain bars by?

1 Answers 7 Views

The average permissible stress in bond for plain bars in tension is?

1 Answers 8 Views

Ratio of permissible stress in direct compression and bending compression is?

1 Answers 7 Views

In a steam engine, one method of obtaining the earlier cut-off with a simple slide valve is by increasing the angle of advance of the eccentric while the throw of the eccentric, steam lap and exhaust lap are kept constant. This method will?

1 Answers 4 Views

For a two stage compressor, if index of compression for higher stage is greater than index of compression for lower stage, then the optimum pressure as compared to ideal case will?

1 Answers 7 Views

If d is the diameter of a bar, ft is allowable tensile stress and fb, is allowable bond stress, the bond length is given by?

1 Answers 4 Views

The length of lap in tension reinforcement should not be less than the bar diameter × (actual tension / four times the permissible average bond stress) if it is more than?

1 Answers 5 Views

If Sb, is the average bond stress on a bar of diameter ‘d’ subjected to maximum stress ‘t’, the length of the embedment ‘l’ is given by?

1 Answers 8 Views

In the triaxial compression test, the application of additional axial stress (i.e. deviator stress) on the soil specimen produces shear stress on?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)